The switch is part of the lamp assembly. qcbt3The lamp assembly uses a Mercury switch similar to a home thermostat. as the switch body is moved (by raising the hood) encapsulated mercury flows from one end to the other of its capsule and makes the circuit for the under hood lamp. To test,remove the connector at the light assembly and check for 12 volts DC. If you have voltage, the circuit is good and you need to replace the light assembly. Usually the lamp contacts get corroded but the assembly is sealed and not owner serviceable.
The brake light switch is connected to the brake pedal and the brake linkage under the dash with a single bolt.
the switch is located on top of the gearbox,under the airfilterbox
There is no brake light switch. There is a brake light pressure censor that is located under the cab where the driver's seat is. T.R.
The brake light switch is located under the dash drivers side under a sound cover held in place by 2 screws, not that hard to remove.
stop light switch is located above brake pedal under dash
the brake light switch is on the top of the brake pedal arm. under dash.
The brake light switch is located under the dash. It is connected to the upper arm on the Brake pedal
the brake light fuse is located on the firewall under the dash beside the park brake second or third up on the left hand side
the brake light switch is located on the brake pedal, near the top. You will have to take off the cover right under the steering wheel to really be able to see it. Hope this answered your question
It is located under the drive side dash. The brake pedal mechanism presses against the switch when you press on.
Fuse and/or switch Switch located at upper end of brake pedal under dash
yes you do have to be a contourcionist to work under the dash of a jeep,I have an 88 wrangler. I have to take the drivers seat out and lay on my back and feel my way to the brake lite switch as it is above the steering colunm.I believe yours is below the colunm