You need to get a plug from a junkyard to figure this out. Mitsubishi wont even help because they figure it would be unsafe to wire it manually even if done by a PRO.
What are the 7 Wires for on a 1994 Mitsubishi Galant ES for?
look at the valve cover there 4 black things on the top from left to right the 1st and 3rd are plug wires and there connect to the coil packs 2 and 4,plug wires can be pulled out with your hand but the 2 coil packs need to be removed with sockets after you've removed them the spark plugs are in the holes
Loosen the four bolts that hold the ignition coils to the valve cover gaset. Then pull each coil out and the spark plug wire attached to it. Pull each wire off each coil and replace with new. Reinstall coils and wires. Reinstall ignition coil bolts.
It is located in the data link connector. There are three black wires. It is the bigger of the three black wires.
A tune up for a Mitsubishi Galant can mean several things. But the most common focus is replacing the air filter, fuel filter, spark plugs, wires and routine maintenance.
The fuel filter on the Mitsubishi Galant is located on the passenger side of the vehicle, under the hood, near the engine. It is a cylindrical device with multiple hoses and wires coming out of it.
Broken spark plug wires will keep almost any car from starting.
a broken valve spring ,a faulty egr valve alot of possibilities
THERE ARE TWO WIRES
Spark plugs, wires, air filter, 5 quarts of oil
The 2.4 Liter Mitsu engine is a hemi--the spark plugs are located in the center of the valve cover. If you pull one of the spark plug wires up and out, you will see that it has about a 5 inch extension that goes down to the plug. Then you can put a spark plug socket on a long extension and stick it down into the hole and remove the plug. It also has 2 "coils" that are in line on the wires, so it costs about $200 to replace the wires.
Bad distributor cap, wires, plugs, injectors, low compression, broken valve spring, vacuum leak. Realey need to know the year, to help you better.