0
While working on the FastEthernet 0-1 interface you realize that it is performing poorly under load after running a diagnostic you discover that there are a high number of late collisions recorded?
Wiki User
∙ 14y ago
That the duplex configuration may be mismatched
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How can you check to see if a fastEthernet interface on a router is connected to the fastEthernet interface on another network device?
Check the network card and the properties are listed there.
How can you check to see if the fastethernet interface on a router is connected to the fastethernet on another networking device?
Smell the router to see if it's in heat.
What is the purpose of FastEthernet interface?
Connects the router to a single broadcast address. e.g. LAN
What does it mean when a user sees the command prompt Router config-if?
On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#
What command will place the router into the correct mode to configure an appropriate interface to connect to a LAN?
UBAMA(config)# interface FastEthernet 0/1Use this UBAMA(config)# interface FastEthernet 0/1 to correcty configure the connection.I Hope this could help. And also online pc repair if your having problems in yourComputer, Fast and reliable accurate service from the exact moment you need id
What is difference between serial interface and Ethernet interface?
The FastEthernet interface of R1 is disabled. One of the default routes is configured incorrectly. A routing protocol is not configured on both routers. The default gateway has not been configured on both routers.
The network containing router B is experiencing problems A network associate has isolated the issue in this network to router B What action can be preformed to correct the network issue?
issue the no shutdown command on interface FastEthernet 0/1
How is the TCP IP configuration information specified by the default router and dns server commands made available?
The TCP/IP information is supplied to any DHCP client on the network connected to the FastEthernet 0/0 interface of R1
Which diagnostic tool helps you in finding a malfunctioning network interface card?
2 (two), or it can also be 50.
How do you erase Airbag fault code in a Volvo S60?
You will need to go to a dealer or a repair facility that has the Volvo Vida diagnostic computer with the Dice interface. A average diagnostic tool cannot access the SRS codes.
What are advantages of using basic rate interface contention resolution in an ISDN network?
Avoiding frame collisions Avoiding transmission time lags Improving network Performance
Where is the diagnostic link connector for 1996 Toyota Camry?
It is located in line with the steering shaft just past the plastic dash material. The interface plug points nearly straight down. The OBDII interface was not in some cars built during 1996.
