0
Why can't you get your key to turn for your 2000 Chevy Monte Carlo after shutting it off is there a reset?
Wiki User
∙ 13y ago
no it didn't
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Is there a reset button on a 2005 Chevy Monte Carlo for the fuel pump?
No.
How do you reset radio in 2000 Chevy Monte Carlo?
Unhook the car battery.
Where is the Electric Fuel Pump Inertia switch on a 99 Chevy Monte Carlo?
GM vehicles do not use inertia/reset switches.
How do you reset the check engine light in a 2003 Chevy Monte Carlo?
unhook a battery cable for about 3 minutes and re-hook.
How do you reset the alarm on 2000 Monte Carlo SS?
you eat 25 corndogs ! :]
How do you reset the ABS light on a 1998 Chevy Monte Carlo?
The light is on because there is a problem with the system. The light will remain on until the problem is fixed. Once the problem is fixed the light will reset itself after a short drive.
How do you reset ignition serurity on a 1999 z34?
how do I set reset ignition security on a 1999 z34 monte carlo
Where is the fuel reset switch located on a 1997 Chevrolet Monte Carlo?
General Motors cars do not have a reset switch.
Monte Carlo ignition won't turn steering wheel not locked?
RESET THE ALARM
Where is the fuel pump reset switch on a 1998 Chevrolet Monte Carlo?
No such thing on this car.
How do you reset alarm on 1999 Chevy Lumina?
on a 97 lumina / Monte Carlo, there is a black wire with a plastic connectere in the right hand side (passenger) of the trunk. ground it out by touching it to metal, bam! you will hear the door locks reset
How do you reset the computer on an 2002 Chevy Monte Carlo after you have installed a new ignition?
Follow the below steps to reset the Computer on your Chevy Monte Carlo: 1) Put the key into the ignition and turn it to the "on" position, but do not start the engine. 2) Plug the computerized scan tool into the diagnostic port under the dash. Select "PCM" on the menu and then choose "codes." Finally, select "clear all codes." 3) Unplug the computerized scan tool from the port. Now turn on the engine and observe the instrument panel to make sure all warning lights have shut off. The computer is now reset.
