it cools itself down, that is normal
rear a/c blend door actuator bad [broken plastic gear]
Check your servos.
How do you remove the instrument panel in a 1998 Ford Expedition 5.4 Engine
Go to this website for description and photos. Copy and paste into your web browser if link isn't highlighted. http://www.autoclinix.com/Expedition/Ford_Rear_AC.php
i have 99 taruas and its my battery relay
The front blower motor is located under the glove box behind the lower trim panel. The rear blower motor is located on the left side in the rear behind a panel
The blower motor is located under the passenger side of the dash panel.
Yes, It`s on the inside of the blower compartment cover panel.
See "Related Questions" below for a different set of instructionsDisconnect the negative battery cable.Disengage the instrument panel insulator from the instrument panel.Detach the wiring connector at the blower motor.Unsnap the instrument panel upper finish panel from the instrument panel.On vehicles equipped with autolamp, Detach the electrical connector from the light sensor amplifier.Unsnap and remove the instrument panel finish end panel from the right side of the instrument panel.Remove the 3 screws retaining the instrument panel to the upper cowl top panel.Remove the 2 screws at each right side of the instrument panel.Remove the 3 screws retaining the blower motor to the evaporator housing.Pull the instrument panel away from the cowl and remove the blower motor from the A/C evaporator housing.If required, separate the blower motor wheel from the blower motor by removing the retainer from the blower motor shaft and sliding the blower motor wheel off the blower motor shaft.
On the Dodge Ram truck, the heater fuse for the blower is on the fuse panel on top of the battery. There is also a blower motor resistor on the blower motor. The fuse to control the heat control panel is in the fuse box in the dash.
Remove the instrument panel silencer from the passenger side of the instrument panel. Disconnect the wire harness connector from the blower motor. Remove the three screws that secure the blower motor to the HVAC housing. Remove the blower motor from the HVAC housing by rotating and tilting the motor as needed for clearance of the blower wheel....
the blower switch itself is located in the instrument panel. it adjust the speed of the blower. the blower resistor, if that is what you are looking for,is located beside the blower motor under the pass. side of the dash