Go to this website for description and photos. Copy and paste into your web browser if link isn't highlighted. http://www.autoclinix.com/Expedition/Ford_Rear_AC.php
remove interior door panel to access power lock mechanism.
The interior door handle on a Hyundai latches onto the locking mechanism of the door. First remove the old handle by unscrewing it from the door panel. Pull the handle out and remove the locking wire. Install the new unit with the locking mechanism in place. Tighten the mounting screw.
First remove your door panel and interior lock module modular with T30 screwdriver. Then proceed to remove the window mechanism and your interior panel. A T20 screwdriver to remove the interior panel and lock module from the inside of door. Disconnect your control module and replace with a new.
Door Panels Removal & Installation 1. Remove the sail panel. (Front Door's Only) 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. 4. The installation is the reverse of the removal.
how do you remove the grill from a 2008 ford expedition?
After unscrewing all the screws on the perimeter of panel you must slide the interior door handle mechanism to release the panel.
remove the inside trim or cut a hole to reach the mechanism and replace the inside trim.
Clicking in a cell won't remove it.
how to remove the lines from the heater core on a 2001 expedition
They are notorious for sticking in the closed position if the manual finger-lift latch pivots on the exterior handle get bound up from rust. You have to crawl inside the back and remove the interior panel to get at the latch mechanism and manually release the mechanism. Then when you have the door open take spray lube and soak the pivots, working the finger latch back and forth until it is free and pivots easily. It should work after all that. The other possibility is that the electric lock mechanism either doesn't worked or is jammed. Same as above -- you have to remove the interior panel and check it out.
The only way to open a completely inoperable latch is to remove the handles and interior panel to access the latch directly. If the lock is disengaged, sometimes a "burglar bar" can reach the latching mechanism from the window well. But normally an undamaged interior handle would be directly connected.
Crash.