Yes, an example is an automobile's ignition coil, which is energised from the battery, via the contacts within the distributor. The contacts open and close, supplying the ignition coil with pulsating current.
1 answer
A "Rectifier" converts AC current to pulsating DC current.
2 answers
The frequency of pulsating DC, often referred to as pulsating direct current, is determined by the rate at which the voltage alternates between its maximum and minimum values. In a typical scenario, this frequency corresponds to the frequency of the alternating current (AC) supply from which it is derived, such as 50 Hz or 60 Hz. Pulsating DC can be generated through rectification of AC, leading to a waveform that oscillates but does not alternate in polarity. The frequency of the pulsating DC is thus defined by the rectification process and any filtering applied to the output.
1 answer
A: Pulsating D.C.
1 answer
AC. is alternating current and Dc is direct current. alternating equivalant to pulsating electricity while direct is a constant draw with little fluxuation.
1 answer
All types of generators induce EMF in sinusoidal wave form. (A.C.) In a D.C. generator the function of a commutator is to convert A.C. EMF into D.C.
The commutator rectifies the output that is the alternating current so as to produce unidirectional alternating current (pulsating DC). This reverses the negative polarity current to a positive one so as the output is a pulsating DC.
1 answer
The term jerky flow needs to be expanded upon to answer your question. It could mean alternating current or pulsating DC current.
1 answer
It was a pulsating match and everyone really enjoyed it.
1 answer
The commutator is the moving part of the electrical switch in motors that reverses the current direction between the rotor and the external circuit. This is applicable in electrical motors and electrical generators.
2 answers
pulsating red light.
1 answer
(a) A current flowing in one direction only; -- distinguished from alternating current. When steady and not pulsating a direct current is often called a continuous current. (b) A direct induced current, or momentary current of the same direction as the inducing current, produced by stopping or removing the latter; also, a similar current produced by removal of a magnet.
1 answer
using a rectifier, which converts the AC signal into a pulsating DC signal, and then using a filter to smooth out the pulsations in the signal, resulting in a steady DC output.
2 answers
its commutator..which converts ac produced by and motor to pulsating dc ...
more the commutator divide more accurate dc..means less pulse in dc
2 answers
Your 12-volt direct current motor may stutter when connected to a pulsating power supply due to irregular voltage levels that prevent the motor from receiving a consistent flow of power. Pulsating DC can lead to insufficient torque, causing the motor to struggle to maintain its speed and leading to stuttering. Additionally, the motor might not be able to handle the rapid fluctuations in voltage, which can result in erratic behavior. To resolve this, consider using a stabilized power supply that provides a smooth, constant voltage output.
1 answer
In a power supply diagram, the block that indicates a pulsating DC output is typically labeled as a "Rectifier" or "Rectifying Stage." This component converts the AC input voltage into pulsating DC by allowing current to flow only in one direction. The resultant output is not smooth and contains ripples, which distinguishes it from a pure DC output. Further filtering is usually required to smooth out these fluctuations.
1 answer
yes you can of you were asking "can you feel anti lock brakes pulsating"
not sure why
1 answer
Because of how a transformer works. Basically a transformer have a primary and a secondary winding sitting close to each other, with the primary connected to the ac source. Pushing ac through the primary wionding creates a pulsating magnetic field. Pushing a pulsating magnetic field through the secondary winding creates an electric current in it. That current will also be ac, but dependent on the number of turns in the windings it will have another voltage.
DC don't give a pulsating magnetic field from the primary winding, and a stationary magnetic field won't generate any electricity in the secondary winding.
1 answer
It might be an aortic aneurysm and you should get it checked out
1 answer
If your lawn mower is pulsating, it may mean that it is not getting enough fuel and the carburetor may need cleaning.
1 answer
When AC full wave is rectified into DC by using bridge rectifier .The DC do not actually behave like an ordinary DC and the DC has a constant value .In fact, it is in pulsating form.This is known as Pulsating DC.
1 answer
A transistor is primarily used to amplify or switch electronic signals and can indeed be utilized in circuits that convert pulsating DC into another form of pulsating DC. However, its primary function is not to transfer but to control and modulate signals. In applications like switching power supplies or pulse width modulation (PWM) circuits, transistors can effectively manage and modify pulsating DC voltage. Thus, while they can work with pulsating DC, the term "transfer" may not fully capture the transistor's role in these applications.
1 answer
A rectifier is used to convert alternating current (AC) to direct current (DC). The rectifier allows current flow in one direction only, converting the back-and-forth flow of AC to a constant flow in DC circuits.
2 answers
A pulsating star will appear to increase in size and brightness as it expands and contracts rhythmically. This pulsation can cause the star to vary in luminosity over time, creating a characteristic pulsating pattern in its light output.
2 answers
Pulsating sprinkler tangles back and forth as it rotates to water across your lawn. This has a standardized faucet connected to the opening close to the bottom of the metal or plastic. Two or more pulsating sprinkler can be connected together using numbers of water hoses.
2 answers
Check your cooling fan motor. If it is no good when it goes on it will make a pulsating sound.
1 answer
A pulsating sensation in your chin could be due to muscle twitching or spasms, nerve irritation, or even stress or anxiety. If the pulsating sensation is persistent or accompanied by other symptoms, it's a good idea to consult a healthcare professional for further evaluation.
1 answer
Pulsating refers to something expanding and contracting rhythmically or in a regular pattern. It often describes a strong or noticeable beating, throbbing, or vibrating sensation.
1 answer
the pulsating universe theory is when the universe expands (the big bang) then contracts (the big crunch) and so on (it's pulsating). according to this theory right now the universe is expanding, but then it will contract
3 answers
Yes: Betelgeuse is a semiregular variable star so it is classed as a pulsating star.
2 answers
i have a friend with this problem and found she had pulsatile or pulsating tinnitus which is caused by a middle ear infection, treated with antibiotics, hope this helps
1 answer
A Huge Ever Growing Pulsating Brain That Rules from the Centre of the Ultraworld was created in 1989.
1 answer
Diodes are used after a center-tapped transformer in a DC to AC inverter to rectify the alternating current (AC) output of the transformer into pulsating direct current (DC). This rectified voltage is then smoothed using filters to produce a more stable DC waveform. The diodes act as one-way valves, allowing current to flow in only one direction, thus converting the AC voltage into a pulsating DC voltage.
2 answers
You might have a pulsating showerhead?
1 answer
A pulsating star is a type of variable star that changes in brightness due to periodic expansions and contractions of its outer layers. These changes can be regular or irregular, and the star's size and temperature vary over time. Examples of pulsating stars include Cepheid variables and RR Lyrae stars.
1 answer