Ford Ranger
Toyota Camry
Dog Behavior

02 ranger edge high pitched whistle under the hood not belt noise was told might be a sensor any thoughts?


Top Answer
User Avatar
Wiki User
2007-03-15 03:41:40
2007-03-15 03:41:40

a vacuum leak can often cause a whistle sound.


Related Questions

Where is the ford ranger 2004 revcounter sensor conected

Where is the crank sensor located on a 94 ranger 4.0 motor

YES - lists a DPFE sensor for all available engines on a 1996 Ford Ranger

I'm not a mechanic / technician but on a 1988 Ford Ranger there might be ( 1 ) oxygen sensor ( upstream sensor )

The 1998 Ford Ranger speed sensor ring can be located on the passenger wheel. The speed sensor ring will be on the inside of the brake rotor.

The 1999 Ford Ranger 3.0 liter engine throttle positioning sensor is located on the cylinder head. The sensor will be near the middle of the cylinder head.

The 2002 Ford Ranger camshaft position sensor is located on the back of the camshaft. The rear engine plate will need to be removed in order to view the sensor.

which year model, what transmission do you have, and which speed sensor are we talking about?

Some of the 1992 Rangers had the camshaft position sensor on top of the engine in the same hole where the distributor used to be. Some Ranger engines did not use a camshaft sensor at all.

The speed sensor on a 99 Ranger 2.5 liter 2WD with an automatic transmission is in the rear differential. It is included with the ABS sensor in one unit.

unplug the clip from the sensor. if your replacing it, you just unscrew the sensor

motorcraft . com just shows ( 1 ) oxygen sensor for all available engines in a 1991 Ford Ranger

There are either two or three wires on a water temperature sensor for a 2000 Ford Ranger 4.0.

The 1994 Ford Ranger pickup truck map sensor is located behind the dashboard, on the passenger side of the passenger compartment. The map sensor is contained in a dust free box.

yes it has both. at least in my 1991 ford ranger does

The 2001 Ford Ranger 4.0 liter V-6 engine map sensor is located on the firewall in the engine compartment. The map sensor will be on the drivers side of the firewall.

It doesn't have a knock sensor on the 4.0 L OHV in a 1993 Ranger ( my 1995 Ford Explorer 4.0 L OHV engine doesn't have a knock sensor either )

Bank 2 is the drivers side of a V6 engine in a Ford Ranger Sensor 1 would be somewhere in the exhaust before the exhaust enters the catalytic converter ( upstream sensor )

On a Ford Ranger ( V6 engine ) Bank 2 is the drivers side of the engine Sensor 1 would be close to the engine before the exhaust enters the catalytic converter

On a 2002 Ford Ranger : The Mass Air Flow Sensor is between the engine air filter and the engine air intake tube

the o2 sensor is located on the exaust manifold

What model year? The earlier 2.3L did not have a MAP sensor.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.