0
1967 GTO 400 ci with a hot start problem Installed a remote start solenoid - still have trouble starting when hot was told to replace solenoid at starter with a 1964 corvette solenoid Will this work?
Wiki User
∙ 14y ago
If you are running a remote start solenoid, which is completely away from the engine heat, and still having problems I doubt that the Corvette solenoid will make much difference. One other thing to check is your initial timing. If your timing is advanced a little too far it can cause these same symptoms. Before changing out that solenoid again or spending more cash dial back your timing a few degrees. See if the hot start problem is still there. It's free and would only take a couple of minutes to check. If the problem is still there you might want to check or replace the starter itself.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What 94 corvette problem?
Why is 94 corvette running hot
When you turn the key in your 87 corvette it just clicks and the battery is good but if you jam starter with screwdriver she starts rite up but only after you get her to click whats her problem?
== == Try tapping on the solenoid(smaller cylinder attached to starter) while someone tries to start it. If it starts then the solenoid is bad and the entire starter solenoid needs to be replaced.
What could be wrong with your starter if the car is not starting up?
Bad starter, bad starter solenoid, or the problem might not be the starter at all.
Where is the horn located on a 2000 Corvette?
We are having the same problem on a 2000 Corvette, were you able to figure it out?
How do you figure out if car starting problem is solenoid?
Sometimes the cylinoid will make a loud whine or humming when engaged if bad but the best way to tell is to remove it and have it tested.
If a new fuel pump has been installed what other things could cause an intermittent starting problem in a 2000 Nissan Altima?
it could be the crank sensor as it is a problem for the altimas.
What could be the problem when you hear the solenoid click but nothing else happens?
You need to replace the starter solenoid .
Why would a the transmission suddenly stop shifting if a rebuilt transmission had been installed the day prior The transmission has sufficient fluid.?
I just had this problem and had to replace the torque converter. Also the two three solenoid was bad..
Your 2000 E150 Will not start but if you Jumper the starter solenoid it starts right up with the key in the on position Replaced the solenoid but the problem persists Any suggestions?
The problem is almost definitely your neutral safety switch. When you jump the solenoid you are bypassing it. The problem is your starter is going and needs replacement
If you have just installed Windows 98 during testing it fails to start after starting Windows 98 message appears what should you do to troubleshoot this problem name at least two ways?
1. You have just installed windows 98. During testing, if fails to start after the "starting windows 98" message appears. What should you do to troubleshoot this problem? Name at least two ways.
What is the problem when an 1986 corvette will not start?
a lot of different stuff
How do you know if a non starting problem on a Volvo 240 GL is due to a faulty solenoid as opposed to the starter itself?
Remove the starter and take it to your local auto parts store for testing.
