Want this question answered?
i hit he curb and put a hole in the oil pan ,i replace the oil pan now the engine cranks but doent start. what could be the problem
could be disdributor
The problem is in spark, or fuel. Rarely the Crank angle sensor. ECU could be going bad too.
check map sensor that was the problem in my 89 2.3 ranger
THE netural Saftey Switch could B bad .
I can't say for certain but I think that year has a crank sensor which could be bad also it could be a fuel problem or even an ignition problem
There are several reasons why a 1996 Achieva engine cranks but will not fire. A few of the reasons could be a bad ignition control module, ignition coil pack, or a crankshaft position sensor.
You need to be more specific about your problem. If it fails to crank, it could be it is not installed properly. Shims may be needed to make sure it engages the fly wheel gears properly.If it cranks, but does not start, then there are many electrical problems that could cause this. This begs the question, did it run OK before replacing the starter?
Vehicle Speed Sensor
TCC Solenoid.
check the fuel lines.. fuel relay, fuses, and if all else fails the pump.
Thermostat is stuck open.