it could be the coil pick up in your distributor
Yes. The Crank sensor monitors the position and rotational speed of the engine to determine timing for ignition. if it is not functioning you will get no spark.
Check to see if you are getting spark (coil) and fuel
An ignition coil is an coil that is used to change the volts in a battery to ignite the spark in the spark plug. This is necessary to get the engine to start up and the car to run.
It could be in need of a new set of ignition wires (spark plug wires).
there are several problems that could cause this on a jeep one is the ignition switch, the starter, the gear changer on the transmission.
plenty of things could be a starter, alternator, ignition switch, bad spark...
The most common failure associated with those symptoms is the Crankshaft Position Sensor.
A bad ignition coil will cause your engine not to have any spark. Without any spark the engine cannot start or run.
Depends on the motor, 4cyl or V6, but it could be the ignition module, or the crank sensor
If it is getting fuel, try a new spark plug. The old plug could be fouled.You start by determining the reason why it won't start. Ignition, compression, and fuel... you need all of them in order to get the vehicle running.
It could be the coil - it could be the spark plug. If it has electronic ignition it could be weak
There could be a few reasons why a 1990 Chrysler Lebaron will crank but not start. The fuel pump could be out or the car could be out of gas. There may be a malfunction in the ignition system causing no spark.