answersLogoWhite

0


Best Answer

Replace the relay! When it makes the noise it has a loose connection. When you tap it, you temporarily knock the loose connection into place. It makes contact. It soon gets out of place and disconnects your circuit or causes a short. Stop messing around. Replace the broken part. It is 15 years old. Mechanical parts wear out and break.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1994 ford Taurus multi-purpose relay makes noise and car won't start. Tap the relay switch noise quits and car starts but then quits running.?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove an ignition switch on a 1996 Ford Taurus GL?

I have a 96 Ford Taurus and need to get the key switch out. Please help.


Where is the kill switch located on a 1994 Taurus gl?

the kill switch?


Which three devices are usually integrated into a multipurpose network device?

-Switch -Router -Wireless Access Point


Where is the transmission switch located on a 1999 Ford Taurus?

no such thing as a trans switch


What if the ignition switch starts the starter and the engine run but unfortunately starter continues running what is the cause of this?

Probably a stuck solenoid.


Were is the heater switch located on a 1998 Ford Taurus?

The heater switch is located in the middle of the car in the 1998 Ford Taurus. It is either above or below the radio.?æ


Where is the multifunction switch on a 94 Ford Taurus?

The signal light switch is part of the multifunction switch on the steering column.


What would cause a 1998 Honda Passport not to stay running?

If it starts but doesn't stay running after you release the key from the start position, it means your ignition switch is bad. Not a huge expense.


Where is the Chevy S-10 multipurpose switch located?

The signal light lever is connected to it. You will find it under the steering wheel.


WHERE is a inertia switch on 1994 Ford Taurus?

my 92 is in the trunk.


Where is the fuel pump shut off switch on a 2002 Ford Taurus?

On a 2002 Ford Taurus : The fuel pump shut off switch ( inertia switch ) is on the passenger side of the trunk , behind the trunk liner ( there is an access hole )


What does the multifunction switch do on a Ford Taurus?

On a Ford Taurus : The multifunction switch is INSIDE the steering column cover The turn signal lever and hazard flasher button stick outside of the cover