Hello... I have the very same problem. To remove the hinge pin, you must heat the center of the hinge where the pin goes through, and use an air hammer with a flat pointed end. Manage the air hammer under the hinge, point on the bottom of the pin and pull the trigger. Steady the air hammer so it doesn't move around on you. ....Good Luck!!!!
Hello... I have the very same problem. To remove the hinge pin, you must heat the center of the hinge where the pin goes through, and use an air hammer with a flat pointed end. Manage the air hammer under the hinge, point on the bottom of the pin and pull the trigger. Steady the air hammer so it doesn't move around on you. ....Good Luck!!!!
The 2002 Jeep Grand Cherokee glovebox is secured with a retaining screws. There are four retaining screws on the top and for retaining screws on the bottom of the glovebox. Remove the retaining screws to remove the glovebox.
Passenger side near the door hinge on the dash housing.
It's bolted on the body, welded on the door. Door pin/bushing replacement guide: http://www.digitalrevo.com/jeep/doorpins.html
Hinges vary in price due to what they are made out of, but you can get a basic hinge for about 4 dollars, but this will vary depending on your location.
Hello... I have the very same problem. To remove the hinge pin, you must heat the center of the hinge where the pin goes through, and use an air hammer with a flat pointed end. Manage the air hammer under the hinge, point on the bottom of the pin and pull the trigger. Steady the air hammer so it doesn't move around on you. ....Good Luck!!!!
To replace the hinge on a 95 Mercury Cougar, remove the bolts holding the hinge in place. Find a replacement hinge from the manufacturer and install it using the right hardware.
To replace a cabinet hinge, you must first remove the screws that attach to the door with either a screwdriver or a drill with screw bit. Next you want to remove the cabinet door. Once you have removed the door, remove the hinge from the cabinet. You can then attach a new hinge. A nice tip is to have a partner hold the door while you screw the hinge back in place.
Have to remove the door, then remove pins and bushings
You replace The hinge pins
To replace the Ford Explorer rear window hinge, you have to buy a similar window hinge. Use a screwdriver to open the hinge and replace the hinge but fitting it in the window.
You do not remove the pin. Remove the bolts holding the entire hinge from the door. You need a helper to do this, and will need help aligning the new door. Mark the location of the old hinge with a marker around the outer edge of the hinge and replace it as close as possible in the exact same location.
Door pin/bushing replacement guide: http://www.digitalrevo.com/jeep/doorpins.html
To repair a broken door hinge on a 1991 Cherokee Briarwood, a new piece of metal should be welded in to hold the hinge. Then, a new hinge should also be welded in that is aligned with the door pin.
You have to replace the whole hinge assembly, they don't make a hinge pin kit for the Thunderbird.
You can replace the top door hinge with bottom hinges on the 1992 as long as the hinge is for the cab doors. The hinges for the tailgate would not work on the doors.
Open your doors, you may need to remove your fenders .Then find the nuts for the hinges, remove the nuts while supporting the door. Be careful of your door. Remove the hinges from the frame, replace, follow through in reverse.