The door hinges on the Jeep Cherokee are welded to the door pillar. I had mine break so I took it to a body repair shop, who had to remove the front mudguard align the door and re weld the hinge back on.
Passenger side near the door hinge on the dash housing.
To repair a broken door hinge on a 1991 Cherokee Briarwood, a new piece of metal should be welded in to hold the hinge. Then, a new hinge should also be welded in that is aligned with the door pin.
To replace the door hinge pins on a 1997 Jimmy you will need to open the door up. Place two jack stands on the front and back of the door's length at the bottom portion of the door for support. Remove the damaged hinge pin with the proper socket. Place the new hinge pin in place and secure it.
Hello... I have the very same problem. To remove the hinge pin, you must heat the center of the hinge where the pin goes through, and use an air hammer with a flat pointed end. Manage the air hammer under the hinge, point on the bottom of the pin and pull the trigger. Steady the air hammer so it doesn't move around on you. ....Good Luck!!!!
Hello... I have the very same problem. To remove the hinge pin, you must heat the center of the hinge where the pin goes through, and use an air hammer with a flat pointed end. Manage the air hammer under the hinge, point on the bottom of the pin and pull the trigger. Steady the air hammer so it doesn't move around on you. ....Good Luck!!!!
On hinge in trunk, may also be in front of owner's manual (which tells about programming it).
Either in the fuse panel=passenger side near the door hinge or under the hood in the relay box near the battery.
The 2002 Jeep Grand Cherokee glovebox is secured with a retaining screws. There are four retaining screws on the top and for retaining screws on the bottom of the glovebox. Remove the retaining screws to remove the glovebox.
Buy a hinge pin and bushing kit then rebuild the hinge on the vehicle and avoid trying to remove the hinge off the vehicle.
Either near the hinge of the passenger door or under the hood in the main relay box near the battery.
Remove glove box by squeezing the sides when open then slide off side hinge. Remove white door by squeezing clips then slide out filter.