Examine the right rear brake light bulb and socket. The bulb could be jammed in the wrong way causing a short. If the bulb and socket look ok check wiring in back leading to the right rear light, it may be pinched or damaged. If the truck has a trailer plug connection check the connections and wiring leading to plug for damage.
You have a short to ground somewhere. Start at each lamp socket, then the wiring and look for problems. Possible bad headlight switch. Also in checking shorts, don't forget the license plate light in addition to all marker lights. Dash lights normally go out when the tail light fuse blows as dash lights are fused from the tail light circut.
Dead short either in wiring, sockets, or in steering column Remove bulbs and try turn signal switch if fuse still blows probable location in steering column
A short in the turn signal switch or the wire in the steering column is shorted. There is more likely a short in one of the bulbs. easy to find remove bulbs until the bad one is found then replace
Wiring for power in buildings is in parallel. If it was in series every time a light or power switch was turned off, the entire building would be turned off. This can be seen with Christmas tree lights when one bulb blows every bulb goes out.
I would be suspicious of the bulbs you're using.
Check wiring and sockets for dead short to ground at: Parking/Tail and dash lights Remove all bulbs and sockets -replace 1 at a time until fuse blows Investigate that socket Check wiring and sockets for dead short to ground at: Parking/Tail and dash lights Remove all bulbs and sockets -replace 1 at a time until fuse blows Investigate that socket
try to determine if it blows when you signal left or right. Once you find out which side the problem is on, there is either an exposed wire shorting out or there is corrosion at the turn signal harness for that particular side, front or rear.
If parking lights and dash lights are not working and fuse blows out, there might be a problem with battery corrosion. Check the components specific to the circuits of the affected lights. It might be loose.
The signal for the assembly in "Lord of the Flies" is blown by a conch shell, which is used as a symbol of authority and order among the boys on the island. Ralph, one of the main characters, blows the conch to call the boys together for meetings and discussions.
Check your wiring and see if there is a bare spot in it to cause a fuse to blow. Check ALL of the fuses as it depends on what circuit you got your voltage from. If the lights you added require more power than the circuit you tapped into can supply, the extra load blows the fuse.
Yes you would use a serial circuit You would use parallel circuit lights for a Christmas tree because if you used series circuit lights, and one of the bulb blows, the rest of the bulbs will go out. But with parallel circuit lights, if one bulb blows the rest of the bulbs will remain their brightness.
If you have any condition in your bathroom where a switch is malfunctioning you need to replace the switch or the device that is causing the problem. This is very dangerous in a bathroom because of the increased danger of shock because of moisture.