answersLogoWhite

0


Best Answer

Factory says- Dextron- II

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1995 s10 4 x4 transfer case fluid?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How can I fix a 1995 Chevy S10 Blazer 4x4 whose actuator works but won't engage?

check to see if your transfer case has to much fluid in it . remove upper plug .


What color is the transfer case fluidin a 2003 s10 zr2?

its a dextron fluid so its red


Kind of fluid for transfer case for 2000 S10 blazer?

There are particular cases for each type of vehicle. It is best to look through your users manual for assistance.


Where is the automatic transmission fluid temperature sensor located on a 1997 Chevy Blazer S-10?

The automatic transmission fluid temperature sensor on a 1997 Chevy Blazer S10 is located on top of the transfer case. It is in the engine compartment.


Where is the transfer case vacuum switch in a 95 Chevy Blazer S10 V6?

on the top of the transmission its on the transfer case with 3 vacuum lines coming out of it.


What grade of manual trans fluid for 1995 Chevy s10 pickup?

automatic trans fluid. Mercon works fine.


What is the crank case fluid capacity of a 1998 S10 Blazer?

Four and a quarter quarts


Where is the speedo cable on a 1989 s10?

The speedometer cable on a 1989 S10 is behind the steering wheel. The speed sensor is mounted on the transfer case tailshaft.


What type of tranny fluid do you use in your 1995 Chevy s10 ls vortech v 6?

Dextron


How do you fix a 1996 Chevy S10 Blazer transfer case?

there are many things that could potentially be wrong with your case. can u engage your 4wheel?


Picture where transfer case is in a 1998 S10 Blazer?

The transfur case is hanging on the back of the transmission, The rear driveshaft comes from the rear end and goes into the transfur case.


Can a 2002 Chevy s10 blazer be flat towed?

With a manual transmission, manual transfer case, or four button electronic transfer case (which has a neutral position), yes. Otherwise, you would have to disconnect the driveshafts.