0
1995 tracker where is the connector to jump for the check engine light to make it blink the codes?
Wiki User
∙ 18y ago
I had the same problem and found that mine was using a six prong plug located in the engine compartment near the battery. It is called a Duty Check Data Link Connector (DC-DLC) and the wires are: 1 2 3 4 5 6 1 - Has no wire 2 - Diagnostice Request Terminal, Blue with Yellow stripe 3 - Diagnostic Output Terminal, Purple with Yellow stripe 4 - Ground Terminal, Black 5 - Test Switch terminal, Blue with Red stripe 6 - Duty check terminal, Purple I jumped terminal 2 with terminal 4 and got my codes, I have some pics at: http://home.stx.rr.com/hesszoo/tracker/ The plug listed as 4 is the one your looking for.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you check engine codes on a 1993 jeep?
With a scan tool, or try turning key on, off, on, off, on and counting the blinks of the check engine light. blink, blink, blink, pause, blink would be 31.
Why does your check engine light blink?
A flashing check engine light is usually an indication of a misfire.
How do you get check engine codes without an obd?
On some if you turn key on, off, on, off, on. The check engine light may start to flash the code. blink, blink, bink, pause blink would be 31.
Why would check engine light blink on my Oldsmobile cutlass?
Probably because you need to check the engine.
Why check engine lamp blink?
A flashing engine light is usually a misfire.
Why does a check engine light blink on a 1998 Mazda 626?
If the check engine light is blinking , an engine cylinder misfire has been detected
Why does the check engine light blink on your 1998 mercury mountaineer?
An engine misfire has been detected
What causes check engine light to blink on and off?
Check to see if your gas cap is tight.
How do you check engine rpm on a 2002 Chevy Tracker?
with a rev counter
What causes the check engine light to blink on and off and then stop blink and turn off?
It is indicating that there is a fault with the engine of the car. You need to take it to a garage for repair/service.
How do i find out what the check engine light is on for on a BMW?
first you nee to check and see if your car is referred to as OBDI or OBDII if its ODBI then you start with the car off.. turn the key to run but do not start the engine.. at this point you have less that 5 seconds to push the gas pedall all the way to the floor and press the overdrive button five times... then the check engine light will stay on.. and then blink... next its going to blink out the code for you for ex. blink-pause-blink blink-pause blink blink blink-pause blink n that would mean the problem code is 1231 just Google BMW problem codes and use that dcode to find out what the issue is..
Your check engine lights blink back and forth and the engine shakes on a Chrysler 300?
If your check engine light is blinking , that means a cylinder misfire has been detected
