2.0 litre DOHC 4 cyl- caps 1 and 6 is 20 ft-lb caps 2-6 is 108 inch-lb
get a manual and use lots of zip ties
Code 54-No cam signal at the PCM-No camshaft position sensor signal detected during engine cranking.
The crankshaft sensor on a 2 door Honda Accord with a 3L V6 engine is located on the side of the engine, near the oil filter. It screws into the side of the block and outputs the loading of the crankshaft to the vehicle's computer.
If it is the original fuel pump then it is probably telling you it is about to quit. have you changed the fuel filter lately?
Best way to diagnose is to scan for codes, but not having that I would guess the ignition module then the crank/cam sensor.
It is inside the distributor. It is only serviced with the entire disributor.
2.7L doesn't have cam bearings. It has Cam towers. There is no Bearing in there. Look for torque of Camshaft Towers.
The camshaft sensor is located on the drivers side top of engine at the end of the valve cover.
Dodge Avenger was created in 1995.
The 2013 Dodge Avenger has 16 valves.
The 2008 Dodge Avenger has 16 valves.
The 2009 Dodge Avenger has 16 valves.
The 2014 Dodge Avenger has 16 valves.
The 2010 Dodge Avenger has 16 valves.
The 2011 Dodge Avenger has 16 valves.
The 2012 Dodge Avenger has 16 valves.
a 1999 avenger es will top out at 128mph I have brought my 2000 dodge Avenger base to 145.