To put a 1996 7.3 powerstroke engine into a idi diesel truck you would have to transfer the ecm and the entire engine wiring harness over the old truck, the 1992 is a non-electronically controlled engine and the 1996 cannot run without a computer because it has high pressure electronic unit injection. This swap is possible, but very difficult.
diagram to replace belt on E350 1994 7.3L
Hello, I just bought a 1992 e350 with the Detroit 7.3 diesel, 207k on it. and I got over 18 mpg with quite a bit of stop and go. The guy I bought it from said it would get 20 - 22 mpg highway.
Usually inside the rear section of alternator
That's the ubiquitous 'check engine' light.
if it is a 6.0 l diesel engine, it is 15 liters
If it is a gas engine, it is located in the fuel tank.
The engine has to be removed.
Depends on which engine it had... gas and diesel engines were available for that vehicle.
The diesel engine that would be in a 2008 Ford E-350 van would be the 6.4L Powerstroke Turbo Diesel V8. This Powerstroke engine got poor fuel economy with about 16mpg highway and 12mpg city.
glowe plugs on 1996 ford e350 .7.3 diesel are under valve cover
No the wiring isn't the same
top center of engine under/behind air filter housing