0
1997 Lumina. Hazard lights cruise control blinkers tail lights work. Brake lights do not. Replaced activating switch and turn signal switch bulbs fuse checked for corrosion and broken wires. Pls help?
Wiki User
∙ 15y ago
To replace turn signal control module requires removing steering wheel. Took mine to a dealer - $245 out the door. Brake lights work great now.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Why would blinkers still not work after you checked all fuses and replaced the blinker lever?
in mark 8's they use a controler to make flashers flash. this module has gone bad
Why is your Blinkers Not Working on your 1991 Plymouth Sundance?
All Bulbs were replaced. fuses all checked, relay switch new and flasher, Also when the relay switch is in it gets really hot. Any suggestions
What is wrong with a 1996 Toyota Camry if taillights do not work you have checked all the fuses and replaced the bulbs daytime running lights work blinkers work headlights work brake lights work?
GO AND BUY I NEW light bulb !
How do you fix blinker on a 92 Chevy caprice already replaced flasher back blinkers wont come on front will but none flash and the hazards wont work either?
Assuming you checked all the bulbs and fuses, it sounds like the signal switch is shot.
What should you do if you replaced brake pads and calibrators and still severe vibration occurs?
You should have your rotors checked and possibly turned or replaced as necessary You should have your rotors checked and possibly turned or replaced as necessary
Why do blinkers reverse light and hazards not work on 95 accent?
Blinkers, Reverses lights and Hazards are all wired into the same fuse. When a short occurs in one of the components all of the lights will cease to function. The fuse should be checked to see if they are in working condition.
You have a 1985 Safari the back brake lights and blinkers don't work Any suggestions on what you should check now?
has anyone checked the fuses and bulbs?
What Parts are needed for tuning up a 1989 Lincoln 5.0 engine?
Spark plugs, distributor cap, and distributor rotor should be replaced. Ignition coil should be checked for corrosion at the post. Clean or replace as needed. Spark plug wires should be inspected for corrosion. Clean or replace as needed. PCV valve should be cleaned. Fuel filter should be relaced. Air filter should be inspected and replaced if needed. Oil and filter should be changed if applicable.
My 1989 jeep wrangler turns over but does not start and the coils have been replaced and the wiring has been checked.?
The timing or crankcase sensor needs to be checked and most likely replaced.
Why don't the blinkers work on a 95 Bonneville if you have checked the fuses and still cannot find the problem.?
it might be the hazard switch all the blinker circuit runs through it.
What made the blinkers go out on my Nissan Pathfiner checked flasher and bulbs what should i check next?
check fuses under dash panel and for short if wired for trailer
Blinkers and hazard lights do not work on your 1996 Honda civic?
If you already checked your bulbs then check your fuses, usually this is the case when all the lights stop working at the same time.
