answersLogoWhite

0


Best Answer

i just replaced my rotors on my 97 ranger , they werepitted and warp and could not be turned

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1997 ford ranger xlt 4 cylinder When applying the brakes front starts to shimmy 30 mph or faster?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Will you damage the valves if the timing belt brakes in a 1998 Ford Ranger?

According to the Gates website , the 2.5 liter four cylinder in a 1998 Ford Ranger is NOT an interference engine , so the answer would be ( NO )


How do you change brakes on a 02 ford ranger?

brakes?


Having brake problems on a 95 ford ranger xlt 2.3l v6 you replaced master cylinder brake booster bled the brakes pedal still goes to the floor?

You need to bleed the brakes.


Are all ranger 10 drum brakes?

Some models of Ford Ranger have ( 9 inch ) rear drum brakes


What kind of brakes are on front of 1988 Ford Ranger pickup truck?

fordparts.com shows disc brakes on the front of a 1988 Ford Ranger


Can a 93 ranger 6 cylinder and transmission fit in a 92 ranger with a 4 cylinder?

Yes.


How do i repair the slave cylinder on my 1988 Ford Ranger?

The slave cylinder on a 1988 Ranger can not be repaired. The cylinder will have to be replaced, then the system bled.


What are the cylinder numbers on a Ford Ranger?

where is the number 3 cylinder located on a 2.5 ford ranger engine


What is a slave cylinder on a Ford Ranger?

The slave cylinder is a hydraulic device that acutuates the clutch. As you depress the clutch pedal it's movement sends hydraulic pressure to the clutch to release it. It's like stepping on the brakes only withe clutch.


How do you remove the brakes on a Ford Ranger?

is it front or rear


Bleeding sequence for brakes on 99 ford ranger?

start at right rear, left rear, right front, and then left front. Always go from furthest wheel from master cylinder to closest.


Will the manual trans from a 4-cylinder Ford Ranger bolt up to the bell housing of a 6-cylinder Ford Ranger?

I am converting a ford ranger automatic (a4ld) transmission 4wd to a 5 speed manual from a 4 cylinder ford ranger. Will it work. What is needed?