answersLogoWhite

0


Best Answer

take and undo the battery for 30sec and that should reset then computer if not then put you key to the run pusishon with out starting it push the gas pettal down to the flower 3 to five times then tern the key of then back to the run posishon with out starting it then off then start the truck theis should reset the computer.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1999 Silverado 1500 starts but you put it in reverse and the kill switch kills the engine Whats going on How do you reset the security system to not kill the truck when you put it in drive?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does your 2000 Silverado with 55000 miles make a clicking noise when in reverse?

most of the time when a u-joint starts going out it will make noise in rewind first


How do you prime oil pump 1999 silverado?

You don't have to prime it. It sits in oil and will prime naturally as soon as the engine starts.


How do you reverse in a stick shift?

you put the gear in reverse and slowly let up the clutch until the car starts moving. then just ride the clutch so you don't kill the engine.


Starts but dies 2000 silverado?

Mass Airflow Sensor


What state social security number starts with What state social security number starts with What state social security number starts with 042?

Such numbers were issued in Connecticut.


What is reverse extinction?

reverse extinction is where an animals population rapidly starts to increase.


What would make your 2003 Silverado 1500 53L shut off a second or two after it starts every time?

Is the security light flashing? Sounds like you have the wrong key or there is a problem with the theft-loc ignition key system


Why would a 2000 Silverado 53 engine start good when it has sat for a while but turn over for a long time before it starts when it is warm?

THE FUEL PRESSURE REGULATOR HAS A PROBLEM WITH IT. REPLACE IT AND IT SHOULD CURE THE PROBLEM.


How do you get your 2001 subaru legacy wagon to lock the doors automatically when Engine starts?

An auto electrician would need to re-program the security system if that feature is available.


Engine starts then dies?

I experienced this same problem before too. The security system could be the problem. The imobaliser shuts of the car if it thinks there is a problem with the ignition(if it was hotwired).


What is it put it in reverse and starts grinding?

it needs a new transmission


99 Chevy Silverado Coolant leaking into the oil?

That is a common problem with the vortec 350 engines. The intake manifold gasket starts leaking in the corners of it. That is where the water jackets are and it's only about 1/4 of an inch wide and when it starts leaking it allows engine coolant to leak into the lifter gallery and into the oil. Need to replace intake gasket as long as you no it did not freeze and crack the engine block.