0
1999 suburban fuel pump replacement Do the fuel lines disconnect at the tank or at the filler line part Is there a special tool needed?
Wiki User
∙ 16y ago
The fuel lines disconnect at the tank and yes there is a tool required. You can get it at advanced or discount auto for a couple of bucks.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Are the tank straps the only thing holding the gas tank on a 97 suburban?
yes, and the foam insulating back could make the tank 'stick', especially if the tank is empty. Don't forget to disconnect the filler and vent lines, as well as the fuel pump lines and wiring harness.
Where do you find a replacement fuel filler neck for a dodge ram van 3500 with a 360?
Junkyard
How do you disconnect the fuel filler hose on fuel tank of a 1999 Suburban so you can change the fuel pump you don't know how to reach the clamp where the hose connects to the fuel tank?
You will have to let the tank down until you can reach the clamp. It will come down enough to reach everything. It is a tough job to do laying on your back.
How do you disconnect the fuel filler hose from the fuel tank of a 1999 Suburban so you can change the fuel pump you don't know how to reach the clamp where the hose connects to the fuel tank?
On some models you can unscrew the bolts that hold the neck at the top where it connects to the body of the vehicle and drop the neck with the tank.Check yours and see if you can.
How do you change the fuel pump on a 1998 Chevy Suburban?
Your going to have to drop the tank. First disconnect the filler tube and overflow tube from the filler neck assembly (It will be easier to drain the tank from the filler tube than from the filler neck. Second, syphon the gas out!!! unless you have a lift and jack/hoist to hold the tank. Remove the two bolts from the straps with the tank being supported. (NOTE; these bolt may be rusted and have to be cut so be prepared to replace them.) Slowly lower the tank, at an angle, until you are able to disconnect the wiring to the fuel pump. Lower the tank a bit more than disconnect the two fuel lines and vapor line. At this point the tank should be totally disconnected. Lower the tank completely to access the fuel pump on top of the tank. remove the old pump and replace. reverse order to replace the tank. THIS IS NOT A ONE PERSON JOB UNLESS YOU HAVE A JACK SUPPORT!!!
How do you fix a hole in car body below passenger door?
The hole can be patches with replacement of the metal or with a body filler. a metal backing piece needs to be put in for the filler to have something to adhere to.
How do you find a fuel pump on a 1984 corvette?
The fuel pump is located in the fuel tank, attached to the fuel gage sending unit, and may be serviced separately. Access is through the fuel filler door in the body.Replacement proceedure1. Disconnect battery ground cable. 2. Remove fuel filler door.3. Remove fuel cap.4. Remove the rubber fuel tank filler neck housing and disconnect drain hose.5. Remove screws attaching fuel meter/fuel pump to tank.6. Disconnect fuel lines, fuel vapor line and electrical connector.7. Remove fuel meter/fuel pump and gasket.8. Replace fuel pump.9. Install replacement unit in reverse order.
How do you change fuel pump on 1984 corvette?
The fuel pump is located in the fuel tank, attached to the fuel gage sending unit, and may be serviced separately. Access is through the fuel filler door in the body.Replacement proceedure1. Disconnect battery ground cable. 2. Remove fuel filler door.3. Remove fuel cap.4. Remove the rubber fuel tank filler neck housing and disconnect drain hose.5. Remove screws attaching fuel meter/fuel pump to tank.6. Disconnect fuel lines, fuel vapor line and electrical connector.7. Remove fuel meter/fuel pump and gasket.8. Replace fuel pump.9. Install replacement unit in reverse order.
Where is the fuel pump on a 1984 Corvette?
The fuel pump is located in the fuel tank, attached to the fuel gage sending unit, and may be serviced separately. Access is through the fuel filler door in the body.Replacement proceedure1. Disconnect battery ground cable. 2. Remove fuel filler door.3. Remove fuel cap.4. Remove the rubber fuel tank filler neck housing and disconnect drain hose.5. Remove screws attaching fuel meter/fuel pump to tank.6. Disconnect fuel lines, fuel vapor line and electrical connector.7. Remove fuel meter/fuel pump and gasket.8. Replace fuel pump.9. Install replacement unit in reverse order.Read more: How_do_you_replace_fuel_pump_on_1984_corvette
Where is the fuel pump for a 1984 corvette?
The fuel pump is located in the fuel tank, attached to the fuel gage sending unit, and may be serviced separately. Access is through the fuel filler door in the body.Replacement proceedure1. Disconnect battery ground cable. 2. Remove fuel filler door.3. Remove fuel cap.4. Remove the rubber fuel tank filler neck housing and disconnect drain hose.5. Remove screws attaching fuel meter/fuel pump to tank.6. Disconnect fuel lines, fuel vapor line and electrical connector.7. Remove fuel meter/fuel pump and gasket.8. Replace fuel pump.9. Install replacement unit in reverse order.Read more: How_do_you_replace_fuel_pump_on_1984_corvette
How do you remove the fuel pump on 1984 corvette?
The fuel pump is located in the fuel tank, attached to the fuel gage sending unit, and may be serviced separately. Access is through the fuel filler door in the body.Replacement proceedure1. Disconnect battery ground cable. 2. Remove fuel filler door.3. Remove fuel cap.4. Remove the rubber fuel tank filler neck housing and disconnect drain hose.5. Remove screws attaching fuel meter/fuel pump to tank.6. Disconnect fuel lines, fuel vapor line and electrical connector.7. Remove fuel meter/fuel pump and gasket.8. Replace fuel pump.9. Install replacement unit in reverse order.
How do you replace fuel pump on 1984 corvette?
The fuel pump is located in the fuel tank, attached to the fuel gage sending unit, and may be serviced separately. Access is through the fuel filler door in the body. 1. Disconnect battery ground cable. 2. Remove fuel filler door. 3. Remove fuel cap. 4. Remove the rubber fuel tank filler neck housing and disconnect drain hose. 5. Remove screws attaching fuel meter/fuel pump to tank. 6. Disconnect fuel lines, fuel vapor line and electrical connector. 7. Remove fuel meter/fuel pump and gasket. 8. Replace fuel pump. 9. Install replacement unit in reverse order.
