The MAF and the MAP sensor both are obviously electronic and you can not tell by looking at them if they are good or bad
One reason that a 2000 GMC Jimmy engine stalls while driving could be your filter needing to be changed. The problem could also be a bad sensor.
Why engine stalls on 1993 Chrysler Intrepid while driving and sometimes at stops?
Stalling when stopping can be a sign of a bad lock-up torque converter solenoid. But if it stalls while in park, it may also be a very bad vacuum leak, especially if it idles rough. I am assuming it has good plugs and plug wires.
The engine stops.
Check for vacuum leaks.
The light comes on when the car stalls because the engine is not running and the pump therefore is not pumping. The pressure will always be 0 when the engine stalls and the light is directly related to pressure. This is normal, you have no problem, other than the engine stalling.
If a car engine stalls when turning, there could be a problem with the power steering pump. There could also be an issue with an emissions control device.
The idle speed needs adjusted upward if an engine stalls when you take your foot off the accelerator while stopping or turning.
i have a 2000 dodge work van 318 engine when i start in the morning it stalls several times until it warms up then ok
vacuum leak
clutch switch is bad
The engine stalls and will not restart.
take it to a mechanic
when kick down the gas pedal to accelerate, the car downshift but then stalls and then engine stays rough until i turn off the engine and restart it then the engine runs normal again till the next kick down.
my suburban wont start
The engine is choking. My '89 did it. Check the throttle body. It might need cleaned out.
check the pcv valve
Type your answer here... If the engine is not running after starting; yes, it has stalled.
The year and engine info would help.
When the engine stalls you lose the power assist.
There's a solinoid in the transmission.Suggest to check that first. Turn on interior lights. Start engine. If the lights go out when the engine stalls, you have a bad ignition switch.
check for vacuum leak or dirty fuel filter
Then you need to have code checked, you can diagnose from there.
Need a little more info. What Model and year of the vehicle?
if you have ran out of gas and engine stalls it will through this code