Use A 5-speed trans from a 4.3 S-10 It will bolt right up You will need the pressure plate and clutch disk from a 4.3 also
The vehicle speed sensor is located at the top of the transmission tail shaft housing.
its on the rear axle housing
ford speed sensor are usually in the differential housing.
It is on top of the transmission under the intake housing. Take the housing off to get to it. It is held into the transmission by a clamp bolt. Not hard to get off.
To check the fluids in a manual transmission you have to get under the vehicle and remove the fill plug on the side of the housing for a manual does not have a dipstick
Where is located the vehicle speed sensor for F-150 XLT 2000 manual transmission, engine 4.2
An integrated bell housing means it is part of the transmission assembly and can't be removed from the transmission. A non integrated bell housing allows the end user to remove the housing from the transmission usually by unbolting it.
speed sensor is located on the fron upper part of the differential the speed sensor ring is inside the diff housing
* 30RH-Automatic Transmission 3 Speed * 32RH-Automatic Transmission 3 Speed * 3550-Manual Transmission 5 Speed * AISIN-Manual Transmission 5 Speed
better gas mileage
These are the options * 42RE-Automatic Transmission 4 Speed * 44RE-Automatic Transmission 4 Speed * AX-Manual Transmission 5 Speed * 3500-Manual Transmission 5 Speed
An autimatic transmission will have a 4 speed transmission and a manual transmission will have a 5 speed transmission.