To change front rotors on a xterra u have to remove the brake caliper and brake guard off the rotor and then remove the gold cap off the hub and unscrew the two screws holding the wheel bearing in then unscew the holding plate that holds the bearing remember which way the holding plate goes when taking off... then remove the hub and the rotor comes with it ... then the screws going around the hub on the out side remove theses and the rotor comes off .. but i also suggest repacking the wheel bearings and replacing brake pads pads with the new rotors ...
how do you change the rotor in 2000nisan xterra
http://rkrenn.com/xterra/howto/bearing/bearing.htm This link get you past the pads, rotors all the way down to the bearings.
yes
timing belt, spark plugs, plug wires, distibutor cap, rotor button, fuel filter
a dealer charges around $1400 to replace it along with the water pump, spark plugs, plug wires, distibutor cap and rotor button.
There are two 10mm tapped holes in the rotor. Use a 10mm bolt in EACH hole, and alternate turning one bolt, then the other to "pry" the rotor from the hub.
how do you remove a distributor rotor on a 92 Nissan sentra
a jack shaft is the small drive shaft from transfer case to front differential, brakes have nuthing to do with removal of a jack shaft maybe you mean removal of front axle
front or rear are the same. you have to remove the caliper and the caliper mounting bracket. you may have to tap the face of the rotor with a hammer to loosen. on the rears you may have to unadjust the rear parking brake shoes.
how to change rotor front disc on 2006 sprinter
The front wheel bearing on a 2001 Nissan Maxima is replaced by removing the wheel, prying off the bearing cover, and removing the retaining pin. The retaining nut can then be taken out, the calipers removed, and the rotor pulled to allow access to the bearing.
you will have to remove the wheels/ rotor and hub assembly , buy a set of new axels from Nissan or after market auto parts and replace the old ones..not recommended unless you have knowledge on suspension work