there is a wall between your trans part and your bottom end where ur crank is. If it is not leaking out of the outer case, then i dont know because it wont be getting past the wall unless it has a hole in the wall... and u will know if that has happened.
The crankshaft comes out of the bottom of the engine with the engine out of the car. Get a manual on your car from AUTOBOOKSONLINE.COM. sorry, i asked the wrong question, i just need to know how to remove the pully of crankshaft, Thanks!
yes, but it more tends to be a burning/tingling sensation, i have 1 in my lower back, so i get the bad pins needles burning/tingling sensations in my buttocks and back of legs, but my exercises are helping, but if you have any exercises would like to hear them thanks j:)
This is caused by the fuel pump burning up. Replace the fuel pump. The easiest way to do this is to cut a hole in back above the fuel pump !!*** CAUTION***!! Be careful there are possible gasoline fumes that could ignite! Take care and watch the fuel lines. Check your fuses. Good luck
check your inside fuse panel. look for ignition fuse. should say ing.
Chances are you have a bad wire or plug causing it ; It is easy for a weak plug or wire to hit without a load ,so if it is time for a tune-up I would replace the wire set and plugs. Check your cap and rotor also. I hope this helps you. Mark Mark thanks for the help. New wires did the trick. Truck runs great. Thanks again!!!!
If u are still burning trans oil than u put the seal in wrong or damaged it replace the seal again note use the right tools
where crankshaft sensor at?1995 Chevy lumina van v-6 3.1 i couldn't find crankshaft sensor. can u tell me where exactly is that thanks where crankshaft sensor at?1995 Chevy lumina van v-6 3.1 i couldn't find crankshaft sensor. can u tell me where exactly is that thanks
The crankshaft position sensor must be behind the timing belt cover next to the crankshaft and behind the crankshaft pulley. The camshaft position sensor is again under the timing belt cover next to the camshaft and behind and the camshaft pulley. Is it the same place in 2000 Camry 4Cyl? Do you have pictures of the location? Hard or easy to replace, and what tools do I need? Thanks alot
you say thanks and then get 2 gallons of milk and a loaf of bread to stop the burning
no thanks, mine are fine.........but thanks for offering!!
The crankshaft comes out of the bottom of the engine with the engine out of the car. Get a manual on your car from AUTOBOOKSONLINE.COM. sorry, i asked the wrong question, i just need to know how to remove the pully of crankshaft, Thanks!
thanks
== ==
because the resources are like gass they can affect the earth by the humans burning wood,and by burning plastic bags thanks folr reading
You can try this method thanks to the video below...
"How do you replace a factory antenna on a 2002 Toyota Sienna?" I am talking about the whole assembly. Thanks
I know how to replace the plugs, but what do you have to take off on the fairing to get to the plugs. Thanks steve