0
3.8 L No codes run's rough rpm's fluctuate between 670-820 Plugswires new Replaced the Crankshaft sensor but still same issue If placed in Drivereverse and let go the break car dies Starts up again?
Wiki User
∙ 16y ago
vacuum leak
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you fix a damaged crankshaft?
A damaged crankshaft will need replaced.A damaged crankshaft will need replaced.
Why does the engine light keep coming on for the crankshaft sensor when it was replaced?
Faulty sensor get it replaced if not check to make sure wire isn't shorting out
Where is the crankshaft position sensor located on a 1999 Oldsmobile Intrigue and how is it replaced?
The crankshaft sensor is in the front of the engine.Above the starter.You will have to drop the starter.2 15mm bolts.Look up and there it will be.
Can you fix a broken Nissan Sentra crankshaft pulley?
No, but it can be replaced. I would recommend taking to a professional.
Replace crankshaft position sensor in 1995 jeep wrangler?
The crankshaft position is on top of the transmission bell housing on the drivers side. The sensor can be replaced by unbolting and unhooking the plug.
Where is the Chevy Aveo crankshaft position sensor located and how is it replaced?
it is located next to the oil filter right above the oil pan
How do you remove crankshaft pulley 4.0L jeep?
I need a video or diagram on How to remove a crankshaft pulley from a V6 4.0L jeepit looks like my coolant is leaking because the seal needs replaced. Have you ever or is there something I'm missing
Does a 1994 Toyota Paseo have a pilot gear in the crankcase?
there is no such thing. the pilot bushing is in the back of the crankshaft and should be replaced when doing a clutch job
What should be done to stop a oil leak from a 99 Chevy Metro crankshaft position sensor?
the seal on the crank shaft needs replaced
Why is it when I replaced my ignition switch in my Cadillac Catera my car just cranks and cranks but will not start?
its not your ignition its your crankshaft sensor that's the same problem i had.
Why does my car surge and won't start replaced thermostat and radiator?
When the thermostat and radiator were replaced, coolant could have dripped into an electrical connector or a sensor could be disconnected or damaged. Check the temperature sensor and crankshaft sensors first.
Where is the crankshaft sensor located in a 2007 Chevy Impala LS?
impala cranking but not starting; replaced fuses, relays, fuel pump and igntion coils.
