Make sure the gear shift is all the way in park. You may have to hold a little pressure against it. Column shift I assume. If that doesn't help, it may very well be the switch. Simple fix.
First, replace the battery. Then, cycle the ignition between on and off three times. Turn the ignition key into the on position, then the off position, three times. The computer will recognize the key, reboot the computer, and release your key.
Battery first. Main Power fuse second. Bad Ground connection third. Ignition switch fourth.
Where is the crank position sensor hole on a 2003 Blazer
I have installed the radio and when the ignition is in the on position it works.When I start the vehicle,it shuts off.Why?
Most major auto parts stores can get you a diagram of the ignition wiring for a 1995 S10 Blazer. You can also research the ignition wiring at your local library.
You will need to remove the retaining ring at the top of your 1978 Chevrolet Blazer ignition switch. Slide the ignition barrel out and remove the wiring harness. Reverse the process to install the new ignition switch.
Your 2004 Chevrolet trail blazer and battery light indicator is always on because the battery has sufficient charge.
No there is not.
You can find ignition coil for a 2001 Blazer on http://www.made-in-china.com/products-search/hot-china-products/Ignition_Coil.html
You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
If you have 2004 Chevrolet trail blazer and your battery light indicator is on, it is probably because of voltage across the battery is 12.1v.
Where is the control module located on the 1983 Chevy blazer
your a fatty
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
To replace an ignition switch on a 2000 Chevy Blazer remove the lower steering column and dash. Locate the ignition switch and pull the end-clip off the main harness. Remove the mounting screws from the ignition cylinder and replace the unit.
You will need to attach the wiring harness to the end of your 1984 Chevrolet Blazer ignition lock cylinder. Slide the cylinder into the cylinder slot. Secure the ignition lock cylinder with the retaining ring.
If your speaking of ignition points, no. The last year that Chevrolet vehicles had ignition points was 1972.
It will not run if you bypass the ignition module (no spark).
The ignition module is located in the distributor, under the distributor cap.
check your regulator. it maybe over charging your battery
The starter cable for the 99 Blazer is connected to the battery cable below the battery tray. A plastic box encloses a fuse that connects that battery cable to the starter cable and the chassis power.
Bad Ignition Module in Distributor.
There is 1 per cylinder.