Best Answer

With my Jeep it was the ground inside the socket. I used a jumper wire from the GROUND inside the socket ( the one on the side of the inside not the bottom ones) and ran it to the battery ground. This fixed it for me until I got a new socket from Ebay. Scott

User Avatar

Wiki User

โˆ™ 2006-09-08 18:27:20
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 89 Comanche assume easy checks are good what are possible reasons for no turn lghts and after jumping circuits holding brake backpowers ignition?
Write your answer...
Related questions

Is it possible to have 2 or more power lighting circuits at home?


Is it possible to take the keys out of the ignition of a 2001 Saturn L Series while the car is still in Drive not moving?

it shouldn't be possible but if it is you probably need an ignition switch

How do you convert voice message to text message using electronics circuits?

It is only possible by using voice-to-text software, you cannot do it using electronic circuits.

How it is possible Diethylene glycol boiling point is 245 while its auto ignition temp is 225 deg and how it is safe during its distillation as its auto ignition temp is lower than its boiling?

yes its possible

How are integrated circuits manufactured?

to understand how integrated circuits work, you must you must know very well about the term "integrated" and the term"circuit". and what the two simply means is circuits joined together. and this compatibility is made possible by semiconductors and with an enhanced technical skill.

Is it possible to bypass the ignition coil temporarily in a 1993 Mazda b2600?

Ignition coils generate the voltage needed to create the spark for ignition of the fuel air mixture, without it the vehicle will not run.

What is meant by lock range in phase locked loop circuits?

The range of frequencies in which it is possible to achieve lock.

Circuits to light a fused tube light?

the two side fused tube light reuse is possible

Why won't your key turn in the ignition of the GM Envoy?

It is very possible that your steering wheel is locked. You may also be having a problem with your ignition system.Ê

Why are resistors used in electronic circuits?

There is many uses for the resistor in electronic circuits, like current limiting, voltage division, R/C oscillators and many more. Without the resistor electronics is not possible

TowCountry Chrysler had ignition cylinder removed on attempt car teft the dealer replaced the ignition car would not start 3 hrs diagnosis done said fuel pump need replacement Is it possible?

It is possible, would be a odd coincidence.

How many states do electrical circuits on an IC integrated circuit have?

Not possible to say without knowing much more. In analog circuits every signal has an infinite continuum of states. In digital circuits every signal usually has two states (some digital circuits have been built with three states), but there may be many many billions of these signals (e.g. 21,000,000,000 is an awful lot of states).

Why meter in and meter out is not in pneumatic system?

Meter in and meter out circuits are not in pneumatics as air is compressible.Hence uniform control of actuators are not possible

How many possible Hamilton circuits exist in a graph with seven vertices?

There are (7 - 1)!/2 = 6!/2 = 360 of them.

How many path do series circuits currents follow?

A series circuit is one in which there is only one possible path for current.

What should you do if your vehicle catches fire?

Switch off the ignition and get out of the car as quickly as safely possible.

Is it possible for the chip in the ignition key for a Cadillac to go bad?

Yes, its not uncommon. Check first to see if the security light is on, on the dash. This will indicate a passlock problem in the ignition system.

What is SCR used for?

Afew of the possible applications of SCR are Power control, Switching, Zero-Voltage switching, Over voltage protection, Pulse circuits, Battery charging regulator, Heat control circuits and Emergency lightning system.

How do i start my astro van when the key will not turn in the ignition?

get a new key or break ignition with flathead screwdriver or try wiggling old ket around Appended Aug. 7th, 2010: Possible pass-lock failure. this is a switch that is part of the ignition switch, and must be replaced with the whole ignition switch.

How do you spell chamanchi?

The name of the Native American (Indian) tribe is spelled Comanche.(the other possible here is less likely, the Robin Williams movie Jumanji)

Identify four possible ignition sources that may be found at the scene of a hazardous?

Ignition sources a the scene of a hazardous materials spill include electronic device, static electricity from clothing, flashlights, and anything that produces a spark. A motor or engine can be an ignition source.

What was the real cause of the Hindenburg?

The two possible causes are a highly flammable compound in the paint, or ignition of the hydrogen.

Why does my 95 grand prix keep running with the ignition key off?

Possible switch or lock cylinder

Is it possible to get an ignition key for a 95 Plymouth neon?

Yes, a Chrysler dealer or a locksmith can make a key.

What are the Possible problems if a engine gets wet?

It may stall and refuse to start if the ignition gets wet.