The fan motor has failed and will need replaced.
And I though Risister should have been spelled "resistor"
your driver side fan should come on at about 220 degrees which is about 3/4 way up the temp gauge and the passenger side comes on only when the ac compressor is turned on, if ur ac doesnt work then neither does ur passenger fan, if ur temp isin red and ur driver side fan doesnt come on then check your relays if ur relays are good then change ur coolant temp sensor and if that doesnt work then ur fan motor is most likely burnt out
Ihave Toyota Camry ac is stop suddenly even the is stop too ?
No. Me No High AC Fan
Your AC fan is not working on the maximum setting because you have a bad blower motor resistor. This is located under the dash or next to the blower motor.
first turn on the truck turn on ac if the fan doesnt turn then pull the harness and check for voltage if there is none check fuses and relays if there is then fan is bad
One reason why an AC heater fan will not work on a Mazda 3 is that the fan is burned out. It will have to be replaced. However, first check to make sure that you have not simply blown a fuse.
Yes, because it will cause your fan to not work at all therefore cause the overheating.
Get a new adaptor.Source: What you said + common logic
Sounds like you cooling fan is not working.
there is a serpentine belt that powers the ac, fan , water pump, and all that.