answersLogoWhite
Mobile Phones
Car Batteries
Chevy Vans
Car Alarm Systems

After installing a new battery in a 91 Chevy van how do you turn off the alarm?

505152

Top Answer
User Avatar
Wiki User
2007-09-18 00:35:04
2007-09-18 00:35:04

Hit the unlock button on your Remote unlocking thing ( Don't know the proper name, but it's The little device that attaches to your key ring and lets you lock and unlock the van remotely), then put the ignition key in the engine and turn to the Start position. The alarm SHOULD stop, but sometimes It takes a couple tries.

1

Related Questions

User Avatar

Insert the ignition key into the ignition and turn it to on, the alarm should shut off.

User Avatar

on 1998 Camry turn key on push and release alarm button turn key off then start

User Avatar

Check battery in remove control.

User Avatar

I have the same problem with a 1997 Chevy Van. The problem seems to be that GM states that a 50 milliamp draw will kill the battery, and that the alarm system is < 50 milliamp, but I can find out how much less. I have killed several batteries because of this. Now the trick is to put in a new battery. When you connect a new battery, the alarm goes off. To prevent this, with the new battery disconnected, turn the key in the ignition to ON. Make sure the door is closed, and then connect the battery. This prevents the alarm from going off. What I did was to install a battery disconnect switch that I use when the van is sitting for more than a week. Now after it has been sitting for awhile, I go out, put in the key, flip the battery switch, hop back in and the car starts.

User Avatar

To shut off the alarm u need to stick the key in the trunk and turn it this will turn off the alarm

User Avatar

turn the on the door twice disconnecting battery and reconnecting works when the alarm wont shut off and is ringing

User Avatar

To reset the alarm on a 1999 Town Car, put the key in the ignition and turn the ignition to on then off twice. This should turn the alarm off if you cannot get it to turn off otherwise. If this does not work, then the alarm is probably an aftermarket and the best thing to do is to disconnect the negative battery cable.

User Avatar

You can reset a 1994 Mercedes S factory alarm by disconnecting and reconnecting the battery. When the battery is reconnected within 20 seconds turn the ignition on.Ê

User Avatar

You must disconnect the battery cable for a short time. Don't for get you must double click the the alarm button to turn off alarm, once turned on.

User Avatar

If your alarm goes off while you turn your ignition key this could be signaling a problem with the vehicle's power. Have your battery tested to ensure that it has enough juice to power your vehicle. You may then want to look for corrosion on the battery posts or battery cable ends.

User Avatar

If it is battery operated, just take out the batteries. if it is plugged into the wall, unplug it.

User Avatar

could be a problem with your alarm, have you recently installed a new car alarm? Have it checked out by your dealer.

User Avatar

To reset an alarm for a 94 Corolla after changing the battery, place the key in the ignition and turn it slightly. Let it remain in that position for several minutes before starting the car.

User Avatar

In order to disable the alarm system on a 2005 Honda Accord, you can either disconnect the battery, or remove the alarm module all together inside the car.

User Avatar

Take your key and stick it into the lock on the door and turn.

User Avatar

== == to engage the alarm press the door lock button on either door panel this will turn on the alarm to shut it off unlock the door from outside either side should disarm the alarm.

User Avatar

disconnect battery and taking no longer than 30 seconds after disconecting batterie use the alarm control to turn off alarm. reconnect battery if this does not work you will have to take car to dealer there is a special tool for plugging into modern cars to avoid complete loss of battery power when changing batteries etc in newer models

User Avatar

Read your owner's manual. This information can be found there.AnswerYou turn off the alarm on a 1997 Jetta by unlocking any of the 2 front doors. The alarm is temporary disabled when opening the trunk. If you set off the alarm because you replace the battery then you have to lock and unlock the doors to turn it off. First, lock all doors, including the trunk. Then reconnect the battery cables. Finally, unlock the doors. Instead of unlocking one of the front doors, you can also disable the alarm. This can be done by, after locking your car - which automatically arms the alarm, wait a few seconds and then turn the key the other direction for about half a second. This disables the alarm, yet leaves the door locked.

User Avatar

First remove battery cable. Second install your key and turn it to on. Third reinstall battery and all should be fine.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.