0
Are there any holes or gaps under the dashboard in which a power cable can be put through to the battery?
Wiki User
∙ 15y ago
Generally, Detroit tries to keep air from the engine compartment from directly entering the passenger compartment, so no, probably no gaps or holes.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you relocate car battery in a 240sx?
I personally did this in my 240sx s-14. I first removed the battery and cut the Red and black Cable. I then bought 0 Gauge Cable (Aught Gauge) and zipped tied this up under my car. I bought a cheap battery box from an autoparts store and screwed this down in my trunk over my passenger side wheel well. I had to buy new battery connectors and again connected this to my new 0 guage cable after I brought this cable up thru one of the holes in the trunk. Connected the battery up and ready to go.
How do you install a solenoid on a 1988 Lincoln Town Car?
The solinoid is normally on the right hand side near the battery under the hood. Disconnect the neg battery cable. Remove the nut that holds on the positive battery cable and install it ont he new solinoid. Do the same on the oposite side that goes to the starter. This is then installed into the same holes that the old solinoid is attched to. This is normally a couple of small nuts and bolts that go through the fender well. Put the negative battey connection back on. Hope that this helps.
How do you reset the clock in a 1986 golf?
if you have a paperclip. there are two holes in the dashboard. you can set the time there.
Are staples required where cables run through holes in framing?
No, staples are not required where cables are run horizontally through holes in framing members. When the cable changes direction from horizontal to vertical runs from the last hole a staple is required, no greater distance that 16 inches from the hole.
What protection is required when cables pass through holes in metal work?
A protective bushing has to be installed so that the outer sheath of the cable is not damaged during the installation.
How do you change the hood release cable on your 1999 Honda Civic?
remove front wheel and inner fender on the driver side. remove the kick panel on the inside. unbolt the cable handle. remove plastic cover from the hood latch and remove ball end of cable. unclip cable retainers, about 4 in the engine area( mark frame to identify holes before removing), 2 in the fender well. pull straight out and reuse. once cable is loose, cut cable, remove bracket and tape old cable to the new one, using it to pull new cable through all the holes to the front- easier than trying to snake it through. put it all back together. takes about an hour
Are staples required where cables are run through holes in framing members?
Staples are not required where cables are run horizontally through holes in framing members. When the cable changes direction from horizontal to vertical runs from the last hole a staple is required, no greater distance that 16 inches from the hole.
Does battery acid burn holes in your jeans?
yes it does
How do you lock the battery down on an Audi A4?
very simple to lock down Audi a4 battery, there is a screw and a base plate lock for the battery, if the battery is bigger or smaller there are 2 holes for you to choose for your screw to be bolted so the battery base plate will be secured. the battery holder is at the bottom part of the battery. To see the 2 holes remove the entire battery cover its so easy to remove the black plastic cover so you can see the 2 holes.
How do you unlock a Lincoln Mark VIII when the battery is dead and the keys are inside?
Lay down in front of the Mark and reach up through the vent holes in the bottom of the bumper cover. You can reach the hood catch from here and release it. Then change the battery.
How does a cricket breath through its holes in its body?
A cricket breathes through holes in its body, by letting in oxygen i the body
This is a spreading out of a wave around corners or through holes?
This is a spreading out of a wave around corners or through holes.
