The blower motor relay switch in the Honda Civic is located at the center of the engine closest to the firewall. The relay is engaged when the ignition is turned to the on position.
The 1989 Honda Accord blower motor relay switch can be found on the firewall in the engine compartment. The blower motor relay switch will be on the passenger side of the firewall.
The cost of a new blower motor for a 1991 Honda Civic ranges between 60.00 and 80.00 as of 2014. Labor to install ranges from 50.00 to 75.00 an hour.
The oil pressure switch on a 2000 Honda Civic is on the top of the motor. It screws in the side of the vtec solenoid.
Hi, I have a honda civic 1991 ex, the blower motor no work 1 and 2 speed
my 01 civic ac blower only work a few seconds and then stop working can you help me please?
Blown fuse? Bad blower motor? Bad blower motor resistor? Bad blower motor switch?
The blower motor is located on the passenger side behind the clove compartment. If you look up from underneath the clove box you can see it.
The wipers on my 1998 Honda Civic were stuck on low so I assumed it was the switch and replaced it, but the problem continued. The local Honda dealer told me that I should replace the motor, which I did, and the problem was fixed.
a 1991 Honda civic motor
The Honda blower motor is located on the firewall in the engine compartment. The blower motors will be on the passenger side of the firewall.
If you know the fan motor is good but it will not work, first check the fuse. If the fuse is good, then it is either the fan motor switch or the resistor pack that is defective.
how do i remove the fan/blower motor on a 2001 Honda Accord LX?
if it doesnt work on 1 and 2 it could be a blower motor resistor but if it doesnt work at all check the fuses, relay and check voltage if it reads 12 v replace the motor
Defective blower motor, blower motor resistor pack, or blower motor speed control switch.
Check to see if you are getting power and ground to the blower motor - if so blower motor is bad. If no power possibly fan switch or selector switch Also check the blower motor resistor, found in heater plenum.
Heater motor switch and or the connection at the switch is melted. Also check connections at the blower motor and blower motor resistor for melt down damage.
If you are saying the blower motor will not work, then check the fuse. If the fuse is not blown, then it is possibly a defective Blower Motor Resistor Pack, blower motor, or blower motor speed control switch, in that order.If you are saying the blower motor will not work, then check the fuse. If the fuse is not blown, then it is possibly a defective Blower Motor Resistor Pack, blower motor, or blower motor speed control switch, in that order.
Bad resistor at the blower motor? Bad blower motor switch?
the switch, or the blower motor resistor, or blower motor usually it the last two at one time
It is behind the glove box on top ofthe motor blower. Where the connectionfor the blower is there are two screws securing the resitors remove these and lift out. There are three coils of resistive wire which are cooled by the air flow.
yes, the motors are interchangeable.
i have the same problem, already replaced the switch. Its the motor. its around $90 new