Yes, if they are not damaged in any way.
not recommended
how tight should we tight the head gasket bolt for a ford f150 Need to know the engine size.
I would not recommend it. The bolts are stretched during the torque procedure.
You can, but I would advise against it. The old bolts have streatched and you should install new head bolts.
The head bolts will not have the same clamping capabilities, since they were stretched on the first installation. You may blow a head gasket due to the bolts losing torque.
where is the CHT sensor on a 2000 ford F150 where is the CHT sensor on a 2000 ford F150
cracked head or a blwn head gasket
It mainly depends on the year it was made. I personally have a 1994 f150 and I had to take the hub out, which consists of a few Alan head screws then you remove the hub asseembly and then it requires a specialty socket to take out 2 more bolts in the hub. Then you take off 5 or 6 bolts that holds the rotor on itself.
The head gasket is about to blow.....Typical ford..
Yes you never reuse headbolts
The drivers side cylinder head is bank 2