0
How tight do the head-gasket bolts need to be for a Chevy c1500?
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How tight do you tighten the bolts of the valve covers to a Chevy 350?
100 INCH pounds.
What is wrong when the wiper blades do not work on a Chevy Corsica?
wiper motor or the bolts holding it tight.
What do you torque the head on a 2002 Chevy cavalier 2.2 l ohv?
you torque the bolts until they are good and tight
What is the torque for valve cover bolts on 454 ci Chevy engine?
15 to 20 inch pounds should do it, or what feels tight with your fingers.
Should all bolts around front pump on 350 Chevy trans be tight?
They all must be torqued at a certain spec. None will be loose.
Why does the bolts of the bracket that holds the power steering pump in place breaks for a 1989 Chevy astro van?
either the bolts are loose, bolts are not number 8 bolts, or the belt is to tight and out of alignment [ADDED] Another possibility is that they were removed and replaced at some time, but over-tightened so over-stressing them. A too-tight belt may or may not affect the bolts, but it will shorten the lives of not only itself, but also the bearings on all the shafts it drives.
How do you keep tight valve cover bolts On a 1983 Chevy 350?
They don't usually need any special effort, but a little loctite 242 would help.
Hard to shift out of park 2000 Chevy Tahoe 4wd z71?
Sounds like something is out of alignment in the transmission area. Make sure all the bolts are tight down there.
You are trying to attach a trans to a Chevy 350 you have a half an inch to go yet before the torque converter hits the flywheel Should you use the bolts to draw it in or will it make it all too tight?
That is normal, Just put the converter bolts in it and it will be alright.
What is the tightening order for Chevy intake?
to tighten a intake manifold start with a center bolt and tigten in a circular pattern towards the ends. tighten bolts in even incraments until tight.
How tight should the head bolts be on a 1994 Geo Tracker Also how tight should the valve cover bolts be?
46-50 ft.lbs. 46-50 ft.lbs.
How tight to make the cap on the cooling system of a Chevy Corsica?
Hand tight
