0
As far as i know the block and head on the earlier model 626's(96-98)also work....is the same engine,the only difference is the intake manifold(which the 2000 626 one is an upgrade for the mzdaspeed protege)and the ignition which is different than the coil-on-plug on the protege////
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Why does your heater not work in a 94 Mazda Protege?
If your heater does not work on your 94 Mazda Protege, check the thermostat. You can also check the heater fuse to ensure it has not blown.
Can a single overhead head for a 1992 Mazda protege work can on a double overhead block for a 1992 Mazda protege?
DONT BE STUPID
How do you open a Mazda Protege trunk when the release does not work?
With the key.
98 Mazda protege blinkers wont work?
Replace the Flasher Relay.
Is the 2000 Mazda protege obd2 certified and will any obd2 tool will work on this car?
To my knowledge, an OBDII scanner tool will read any OBDII system in any vehicle. And yes, the 2000 Mazda has the OBDII system. Incase you did not know. All vehicles sold in the US 96 and newer are required to have an OBDII system.
If you have a Mazda Protege '91 which has a hold light blinking and the speedometer does not work what is wrong with it?
it could have a bad speed sensor
Where is the thermostat on a 2000 Mazda protege 1.6 L engine?
The thermostat on this particular car is located behind the air cleaner assembly. If you need to work with this piece make sure you have proper protective gear.?æ
Will a replacement air intake hose for a 1.5L 95-96 Mazda Protege fit and work in a 1.5L 98 Protege?
No, you'll need an intake hose for either a 97 or 98
Where the ecu chip located in a 1999 Mazda protege will it help your stalling in second gear problem?
how do ecu chips work how do ecu chips work
What would cause the power steering to work intermittently on a 1997 Mazda Protege 1.5L?
Check for a loose power steering belt.
Can 1997 Mazda protege auto transmission swap to 1999 Mazda protege?
not likely. the 1997 Mazda protege is a different chassis than the 1999 protege (BHA to BJ, respectively). the two transmissions between the two generations are also different, the BHA utilizing the FB4A-EL automatic transmission and the BJ utilizing the FN4A-EL automatic transmission. they also have different engines. you're better off going to a junkyard and pulling a auto trans from a third generation protege (1999-2003)...that would work. if you have any further questions, you can follow this link: www.protegefaq.net hope this helps!
How do fix your windshield wipers on your Mazda Protege?
i put a new windshield wiper moter in and the fuses are fine but my wipers still wont work
