It should if they're both the 183 and the motor mounts are the same. therangerstation.com is the best place to ask. but I'm pretty sure if they use the same motor mounts and they're both the 183 they'll fit. you could ask them and they might have even preformed one in the past and they could help you out in their forum. hope it helps. but i would def. check out therangerstation.com they'll be glad to help you out with everything.
The 2001 Ford Ranger 4.0 liter V-6 engine map sensor is located on the firewall in the engine compartment. The map sensor will be on the drivers side of the firewall.
repair manual fora front differential on a 2001 ford ranger edge
There are ( 6 spark plugs ) on the Ford 4.0 liter V6 engine
Ford Ranger Edge
replace lower ball joint on ford ranger 2001
It's deep in the engine. You'll have to remove the top intake air and work your way down from there.
a malfunction has been detected , get it checked out by a professional
2002 Ford Ranger Edge 3.0 L or 4.0 L V6 engine number 5 cylinder is the middle cylinder on the drivers side.
the pcm is located along the upper edge of the firewall in the engine compartment..
on a lhd its on the left rear edge of the engine block. this may be reversed for rhd.
I don't know if it is the same as the 1994 Ford Explorer but check in the right front passenger footwell , just to the right of the transmission hump , on the toe board , under the front edge of the carpet
You air bag it by using air bags. Not the kind in the steering wheel btw.
an autoglass shop.
Under the engine is the oil pan. The plug is located at the bottom rear edge of the pan, facing the rear of the engine.
If it's the same as the 1994 Ford Explorer : In the right front passenger footwell , under the front edge of the carpet , mounted on the toe-board , to the right of the transmission hump
If it's like the 1994 Ford Explorer check under the front edge of the carpet , in the front passenger footwell , just to the right of the transmission hump
On a 1994 Ford Ranger : Check in the front passenger footwell , under the front edge of the carpet , mounted on the toe board just to the right of the transmission hump I believe that is where the fuel pump inertia switch is on a 1994 Ford Explorer
how far have you gottan on the dorr glass email me at firehouseint41yahoo.com and i can talk you threw it
if you dont see them right on top of the engine them you dont have them......... you have what they call c o p or coil on plug. this setup only has a coil and a boot that sit right on top of the plug.
Firing order is 1-4-2-5-3-6. - Haynes Manual #36071. 1993-2005 Ford Ranger Pick-ups.
If you have a long bed ranger then the answer is no. The edge was a short bed step side.
The 2002 Ford Ranger owners manual shows ( 4.5 quarts ) with filter change for the 3.0 L - V6 engine
I BELIEVE the fuel pump shut off switch / inertia switch is in the front passenger footwell , under the front edge of the carpet , mounted on the toe board , just to the right of the transmission hump on a 1994 Ford Ranger