I'm not familiar with specs. of the 4.0 V-6. What I can tell you is I pulled my boat (1999 Stratos 17.5' 150 Evinrude) from S.E. Minnesota (Winona) to Yellowstone (1150m) with a LOADED down 1996 Chev. Astro van with a 4.3L V-6, auto and I dragged the same boat twice to Port Mansfield, TX. (1550m), once with a 1999 Ford F-150 4x4 with a V-6, 4 spd., in the 285 C.I. range (don't remember exactly) and once with a 2003 Chev. Silverado 4x4 with a 288 C.I. V8, auto. Had no problems on any of the trips. You won't win any races, but it can be done. Pulling it out at the landing would be my biggest concern. Boats that size are very heavy. BTW, The F-150 also had a large, cab-over, slide-in camper to carry along. Hope hat might help. Also, 3 months ago, I was looking at a Ford Escape at the dealer's and I asked if it could handle a boat that heavy. They didn't say no... but they also didn't say yes, either!
Torques motor 4.0 ford ranger?
how do you change motor mount on 2002 ford ranger
How to peplace A RANGER transfer case SHIFT MOTOR
not really
as long as it is the same size motor it should
The replacements for the motor of ford laser kb are JUKI or SINGER
It is usually ( at least on a 2000 Ranger) locted on the blower motor housing in the engine compartment.
No.
There are several motors in disc players. First, there is a platen motor to rotate the disc. There are normally two motors for the laser head to move the laser across the disc and to raise and lower the head. These keep the laser tracking the disc correctly. Finally, there is a motor to open and close the disc tray.
There is a few different sizes motor you can put in a 2000 Ford Ranger. It all depends on what you are wanting to use the truck for.
On a 1995 Ford Ranger : The heater blower motor is in the ENGINE COMPARTMENT , near the firewall , on the passenger side of the engine
Can the oil pump be replaced on 1994 Ford Ranger 4.0 without pulling motor?