The difference between a gully trap drain and a floor drain is placement. A floor drain is in a floor, a gully trap drain goes on an external wall.
An S trap would go through the floor. A P trap goes through the wall. As long as the drain is below the bottom of the sink, it should drain. Distance between the bottom of the sink, the trap and the drain does not matter, it just changes how much water stay in the drain. Normally it is just in the trap, but it can be above the trap if circumstances cause the trap to be lower than usual.
If you can look under the sink, lavatory, or perhaps in the basement under the washing machine . . . a P trap is the drain pipe coming out of the bottom of the sink, or whatever. If that drain pipe goes down, then curves and goes up again, then goes sideways into the wall, then it is a P trap, so named because it look like the letter P if you hold your head just right and squint a lot. The other common trap is an S trap . . . it's the same as the above, except instead of the drain pipe entering the wall, it curves down, again, and goes down through the floor. Its shape is similar to the letter S, if you hold your head just right yada yada. If the drain pipe goes straight down into the floor or has an elbow, making it go through the wall, then there may be no trap at all. (Maybe: . . . the P trap for my bathtub may be found by tearing into the ceiling on the next floor down . . .)
Assuming the horizontal discharge line is connected to the drain system inside the wall, you will need to remove the wall section to determine if that line can be lowered at the elbow or "Y" connection to an acceptable slope. Once you have lowered the horizontal it is easy to find an extension fitting for the down spout of the "P" trap.
Yes, but dont forget the pea trap.
The difference between a gully trap drain and a floor drain is placement. A floor drain is in a floor, a gully trap drain goes on an external wall.
An S trap would go through the floor. A P trap goes through the wall. As long as the drain is below the bottom of the sink, it should drain. Distance between the bottom of the sink, the trap and the drain does not matter, it just changes how much water stay in the drain. Normally it is just in the trap, but it can be above the trap if circumstances cause the trap to be lower than usual.
An S trap is not allowed in a plumbing system. Only a P-Trap
As long as the pipe going into the wall is straight, the rest of the drain pipe can be routed however it needs to be. Very often the trap is at an angle to the pipe in the wall.
A P trap goes thru the wall, an S trap goes thru the floor.
The shape of the drain. A P trap drains out the wall. It looks like a P laid on it's side. An S trap drains in the floor. Again if you laid the S on it's side.
A geologic trap is porous and permeable sandstone containing deposits of water and hydrocarbon.
The drain under a sink when it goes thru the wall instead of the floor. If looked at from the side, it would look like a P.
no, in fact most plumbing codes require a 2" drain/trap for washing maching drain.
If you can look under the sink, lavatory, or perhaps in the basement under the washing machine . . . a P trap is the drain pipe coming out of the bottom of the sink, or whatever. If that drain pipe goes down, then curves and goes up again, then goes sideways into the wall, then it is a P trap, so named because it look like the letter P if you hold your head just right and squint a lot. The other common trap is an S trap . . . it's the same as the above, except instead of the drain pipe entering the wall, it curves down, again, and goes down through the floor. Its shape is similar to the letter S, if you hold your head just right yada yada. If the drain pipe goes straight down into the floor or has an elbow, making it go through the wall, then there may be no trap at all. (Maybe: . . . the P trap for my bathtub may be found by tearing into the ceiling on the next floor down . . .)
Shower drain goes into a trap under shower. Continue piping from trap to drain line.
Your kitchen sink should already be vented if there is a p-trap draining to the wall. if it is an s-trap it is not vented and not to present code requirements. The dishwasher drain goes into the side of the disposal and the disposal should drain to the trap. A separate vent is not required for the disposal or dishwasher as the trap for the sink is what requires a vent.