0
Yes.. look on line ebay or a junk yard.you have to buy the who throttle body.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Why is the 2004 Ford Explorer XLS in limp home mode?
There is problem with the electronic throttle and it puts a 30mph limit on your engine.
What does it mean when engine light amber color Restricted Performance comes on for a 2000 JX8?
When the check engine light is activated the resricted performace message which is like a "limp home mode" to work with the fault the vehicle will restrict timing, trans operation and throttle body response
What does the TPS sensor do?
Throttle Position Sensor (TPS), it detects how open the throttle body plate is to govern how much fuel is delivered to the engine. One of the myriad of inputs your engine control module uses to control your engine. If you are getting a fault code due to the TPS, try cleaning the throttle body out with a spray of throttle body cleaner (not carb cleaner) carbon buildup can cause it to stick. If it does stick open, some vehicles will default to "limp mode" to keep them from accelerating uncontrollably.
Where is throttle position sensor 2003 dodge ram?
If it is an 3.7L or 4.7L engine it is on the throttle body mounted on the side. If it is a hemi engine there are two throttle position sensors. The throttle body is electronic. There is a position sensor mounted underneath the battery hidden behind a cover. The accelerator cable goes from the gas pedal to this sensor. This sensor sends info to the PCM (powertrain control mondule). There is also another position sensor inside the electronic throttle body which tells the PCM what position the throttle plate is at. These throttle bodies on the hemi engines become dirty and cause codes like a P2175 and 2106. It will also make the ETC light flash, and cause low acceleration and limp in mode problems. Cleaning this throttle body will correct this.
What is limp mode in cars?
enables limp home without damaging the engine.
How do you get a 1995 Dodge Intrepid out of limp home mode?
fix the problom that put it in limp home mode then reset the computer
What is the turbo limp module 06 Volvo s60?
Limp home mode is just as it sounds. It goes to a preset load of values to allow the car to get you "limp" home or to the repair service. All engine and transmission performace is reduced. There is no such thing as a "turbo limp module".
How do you fix a P0705 code in my Infiniti G20?
Automatic Transmission Valve Body IS BAD AND NEEDED REPLACEDA MANUFACTURER Valve Body WILL HAVE A STEAL SLEEVE AND ALL NEW PART FOR THE VALVE AFTER BEING BORE OUT.FLUID IS LEAKING BY THE PISTON TRANSMISSION / IF TRANSMISSION SHOP DOES NOT INSTALL A NEW VALVE BODY SAME TIME LIMP MODE WILL COME SOON.NOT CHEAP OR NEW FACTORY TRANSMISSION / I AS GETTING LIMP HOME MODE 2-5 TIME A WEEK. FOR 8 MONTHS I REPLACE WITH NEW VALVE BODY NO MORE P0705 (LIMP HOME MODE)
You put your Nissan Pathfiner 2003 in gear but no rpm to move?
I have had this problem, sometimes the car moves or wait for a while and it will work. Sometimes there is no throttle response at all. The check engine light is not on, or if it is on you have a certain amount of " starts " on the car before the problem reappears, this apparently is called Limp Home Mode, eventually it will not work at all...you can solve temp. by clearing codes on a battery disconnect but will have no data for shop tech. Long story short its the small computer device in the throttle body which does not come separately from the throttle body...only 1 hour labour and cost 1100.00 cdn at the dealer. Hope this was helpful.
How do you turn off wrench light 2004 explorer?
According to the owner's manual , the wrench light is for the electronic throttle control . It illuminates when the engine has defaulted to a " limp home " operation . REPORT THE FAULT TO A DEALER AT THE EARLIEST OPPORTUNITY (Helpfull)
What is wrong with your 1998 Jeeps gas pedal if it just went limp?
Either The throttle cable broke or more then likely the springs in it broke.
When i press on the gas pedal of my 1992 grand prix le it will not accelerate what could cause this?
If the gas pedal is conpletely limp, the linkage to the throttle body is disconnected somewhere. I need more details; send to bulruq@yahoo.com and I'll try to help.
