This could actually help your 10 seer condensor run a little more efficiently but make sure you find out if your old air handlers evaporator coil used a cap tube or a expansion valve to meter freon,because if u are going from a cap tube to a expansion valve evaporator coil u will need to add a hard to start kit and time delay for the compressor,or u will wind up hurting your compressor. any service company should be able help u with this. Good luck!
It does Not effect on the operation of a condensing unit
I have been told that if you are going to replace a 10 seer with a 13 seer, you have to change the coil on the inside unit to work with a 13 seer heap pump. In order to gain the extra energy efficiency yes you would need to replace the air handler as well.
pressure drop in inlet filters and poor maintenance of equipment
Ac compressor
When the compressor fails, the high vapor pressure refrigerant is no longer condensed. Without a phase change of the refrigerant is refrigerator will not cool.
Inefficiencies in the compressor of a gas turbine cycle increase the back-work ratio and decrease the thermal efficiency of the gas turbine cycle, since they increase the compressor work.
Replacing the water pump and belt should not affect turn signal operation.
A Typical Air Compressor used in an air conditioning system is used to compress the vapor refrigerant to a higher pressure. If your compressor is not good enough to compress to the required pressure then your air con. will not provide a good cooling effect. P.S. : The temperature when changed on the main panel will directly change the pressure of your compressor which will affect the room temperature.
you might die from carbon monoxide
Yes, whether thermal insulation or electrical insulation, replacing air with water in the voids of a material will affect its insulating abilities.
No, as being a master mechanic, it would have nothing to do with it.
It can change the accuracy of the speedometer.