answersLogoWhite

0


Best Answer

gotta take it out

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you abandon the fuel pump in the gas tank of my 89 Chevrolet 1500 suburban and install an electric holley fuel pump?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you install a duralast engine management ignition in a 2003 Chevrolet suburban 1500?

can you sholme the diagram how to installl a duralast engine management ignition in a 20003 chevrolet suburban


Will 24 inch rims fit on a 2005 Chevrolet Suburban without any problems?

If you install the correct size tires for these large wheels.


How do i change the ignition module in a 1998 suburban?

Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.


How do you replace a car antenna wire on a 2000 Chevrolet Tracker?

If it is electric, take it off and then take it apart and install the ant.


How do you install projector headlights on a 1998 Chevrolet Corvette?

How do you install projector headlights on a 1998 Chevrolet corvette


How do you replace the battery on a Chevrolet suburban?

If you don't know how to change something as simple as a battery then perhaps you shouldn't try. Buy a new a battery at Autozone/Advance and they will install it for free in less then 5min.


How do you install a starter in a 1977 Chevrolet caprice?

How do you install a starter in a 1977 Chevrolet Caprice Classic with a 5.7 liter motor?


How do you install a passenger airbag on a 1998 suburban?

suburban1998


WHO HAS A diagram on how to install heater core in 1988 Chevrolet suburban?

You can get that from [http://www.themotorbookstore.com/sierra.html Here] Good Luck and Remember.Change Your Mind, Not Your Oil.Use the First In Synthetic Motor Oil's.See My Bio For Information & Contact Details.


How to install an Electric brake?

To install electric brakes, first remove the wheel. Then remove the dust cap, nut, and washer; this will be the place where you install the electric brakes.


How to install an electric fence?

Electric fences can be tricky to install if you do not have the proper directions. Here is a link to how to install an electric fence properly - http://www.afence.com/Electric_Fence/how_to_elecfence/elecinstall.htm


How do you replace a throttle position sensor of a 2003 Chevrolet suburban?

It is located on throttle body, opposite side of where throttle cable is located- Unplug it, remove any screws or bolts holding it on then install new part in reverse order.