of course you can
Are you stuck ? How ?
Bad solenoid, leaking bags
you just do! you have conventional suspension, there is no need for one...
You dont. The Rivy has a automatic air suspension. If the suspension is flat, the motor could be bad, or, the air ride sensor might be bad.
Either your Air Ride switch is turned off or you have a bad compressor. My compressor died on me because of a bad selanoid... have a mechanic look into it. be warned, it can get expensive.
there are several causes to the air pump. the first and most obvious is the air pump (compressor) itself. if you do not hear the compressor pumping air or if you do not feel the slight vibration of the compressor when you put your car into drive, then it's probably the compressor that has gone bad. if the compressor is coming on and you do not hear any air leaking, then your problem could be the height adjuster, located on the suspension bags themselves. Bronconvict: another possibility includes the compressor relay switch. This switch controlls the power to the air bag suspension compressor. This switch is known for burning out when the suspension compressor is working too hard. This can also be caused by a bad/corroded GEM module (due to notorious winshield leak). i had to replace "height sensor" on driver side . part was $200.
Bad compressor? Air leak in system? Excessive vehicle weight?
You have a problem with the air ride suspension. Sounds like a bad compressor or a leak.
Check wiring again. Check for bad ground. Recheck all connections.
Bad height sensor or air suspension compressor has died? If you hear the pump, then it might be the sensors. If there's nothing, could be a blown fuse or the system was swtiched off (switch in the trunk)
No, a bad rear sensor to an air suspension compression would not directly make a motor not work. It can cause a battery to drain which would cause starting issues.Ê
AnswerSwitch accidently shut off?Malfuntioning compressor?Bad air bag?Broken or disconnected air line?so how do i fix it?
Bad bearing in compressor? Bad bearing in compressor?