You can bypss the EGR by putting a bolt in the vaccum line going to the EGR valve blocking the EGR solenoid or alot of people make a plate replacing the valve with a plate but it will set the check engine light its better to just fix it.
I haven't looked at a 1996, but it probably threads into the valve cover.
The EGr is located next to the fire wall, next to the valve cover on the drivers side of te engine. good luck
If the 4.3 Chevrolet engine is new enough to have an EGR valve it would be located in the exhaust pipe where it meets the engine. Some vehicles did not start using this device until after 2000.
Inside the evaporator case which is behind the glovebox
you take a car battery charger and out the negative on the antna and positive to the body and turn it 0n
it shouldn't have one it is fuel injected and thus that is computer controlled
Timing on 1997 pontiac grand am 2.4
Yes it should. The difference is the transfer case, which is externally bolted on the transmisison.
Yes, need an electric fuel pump, o2 sensor and tpi computer and wiring harness This combination could increase the compression ratio. Watch out for detonation. Premium fuel may be required.
Disconnect the heater inlet and outlet hoses at the firewall and then connect them together. You can buy the parts necessary at any auto parts store. Just tell them what you want to accomplish and they can sell you the parts needed.
No.
an earthquake