you will need a press. dont try to hammer them in. you can have a shop press in the races for you then you can install them yourself. also check into getting a set of loaded rotors that have the bearings in them.
if you meant a cylinder rod then you must take off the oil pan gasket and remove the oil connecting rod cap bearings to the cylinder rod- they cylinder must be removed from the top of the engine- to do this you must remove the cylinder head- you must use a ridge reamer to clean the ridge then remove the cylinder and rod from the engine - there is usually a reason the rod is bad- check bottom pan for damage to the bearings and check the cylinder for scoring or damamge- replace any bearings or connecting rods that are out of spec by using a plasigate you can check lower bearings and cap bearings check specs on piston rings and cylinder walls
Because canadians needed someone, they were so alone
are you talking about the front or back? the back bearings are a non serviceable part, the in order to change the bearings u need to change the hub, the front bearings can be separated, but chances are if you have to change your hub, bearings will have to be changed also, you will damage the bearings trying to remove them and put them back in, so my answer is yes. get the parts yourself from ecstuning.com and you will save alot of money over dealer or most shops.
How do I change a wheel bearing
there is no such thing as timing belt bearings...... are you posibly thinking of an idler pulley? or cam bearings?
Well climate change can make lots if other environmental Issues
How do you change the wheel bearings on a Chevrolet aveo 2005
How to remove rear wheel bearings on a 1978 corvette..?
Instructions on how to change the rear hub wheel bearings on a 1996 Chevy cavalier
It gets pretty hot. Some of the damage to your bearings, journal and cylinder wall surfaces in the engine. If you don't change your oil & filter in the recommended time, it becomes clogged and causes extensive damage to the engine. The price of a new engine? $4,000. The price of an oil & filter? Under $20.00
Just remove pan and change bearings.
I can change voucher date by pressing F2