Top Answer
User Avatar
Wiki User
2007-12-06 07:04:18
2007-12-06 07:04:18

NO.. sorry not with out tons of part swapping..

head over to for more answers


Related Questions

well i had to pull my front bumper off to put the headlights on. I have a 1997 prelude so i don't know what year you have but i would guess the front bumper will have to come off.

First remove the front clip (headlights and grille and plastic covering the bumper.) The rest will be obvious.

Does anyone know how to remove the chrome part of the front bumper on a Ford Ranger XLT

It is clipped to the back of the front bumper, either to the edge of the centre grille, or to near to the fog light opening, dependant upon the bumper type. It is clipped to the back of the front bumper, either to the edge of the centre grille, or to near to the fog light opening, dependant upon the bumper type.

How to replace front middle grille in a 2006 cobalt ls

Remove the bumper. There are clips on the top of the grille, as well as one screw in each fenderwell. There are also two screws and two 10mm bolts underneath the front bumper. Remove and pull the bumper straight out. The headlight is held in by four 10mm bolts.

You can't - well, you can.. but the front bumper cover and the grill are all one piece

They are near the front headlights, under the front bumper. You Can see them if you look.

Yes, but your 95 headlights will not fit. You will need headlights from a 97,98, or 99.

According to the manual,you have to remove the front bumper

Yes you just have to change the headlights from a 1998 to the 1996 with the bumper change.

Assuming you mean a 2003 Taurus, yes Actually while the bumpers between 2004 and 2003 taurus will bolt up correctly the two years use a different grille. You'll have a gap between the bottom of the smaller 2003 grille and larger grille opening on the 2004 bumper. Putting a 2003 bumper on a 2004 the 2004 grille is too big. you can shoehorn it in there or replace it with a 2003 grille.

The headlights on a 95 and 96 are longer than the 97-99 headlights. For them to fit you ave to change the front bumper as well.

No. 98 and up have an entirely different front end, to include core support, bumper, grille, and headlight assemblies. You can switch the two (I put a 98+ S10 grille on my 97 Blazer), but you'll need to change the core support and bumper (since the 94 - 97 models have the turn signals in the bumper), as well as the grille and headlight assemblies. You'll also want to be sure to get composite headlight assemblies (they have two bulbs, vs. the sealed beam headlights, which only use one).

You will need to remove the front bumper to access the lower bolts which hold the headlights on. fairly simple job.

Yes you just need to change the headlights and bumper lights along with the bumper

no it will not. To fit 97-98 headlights onto a 95-96 240sx you will need these 97-98 240sx parts: headlights hood front fenders front bumper front grill maybe the front bumper support

my understanding, as for most repairs on the newer VW is to remove the front bumper and grille of the car. it sounds cumbersome and overwhelming but it's actually not that bad of a procedure. i have a 1996 jetta and it takes me 20 minutes to remove the grille and bumper.

No it will not fit. You would have to use the 2006 fenders, grille and Headlight assembly to fit the bumper.

No it will not, without modifications. The spacing on the brackets are different. Just bought a 2002 bumper this morning. After changing out the grille, I attempted to put the bumper on the bolts would not line up.

1.Open the hood 2. Remove the upper radiator air baffle. 3Remove the push in retainers from the upper grille. 4. Remove the circle retainers from the ends of the grille 5. Pull forward and up to release the grille retainers. Remove the grille from the front bumper fascia

Open the hood and remove the grille. The grille will have about 5 7mm, short bolts. Once all fasteners are removed, slide the grille either to the left or right. It will take some persistence, but be gentle. Once removed the bumper can be removed by removing the torx screws. \ It is a simple job.

No, they are not a direct fit, the 96-98 front clip (hood, fenders, bumper, headlights and grill) is different than the 99-00 front clip

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.