NO - all bolts are needed, (that's why they tapped holes for them )
Remove the power steering pump. I just did a water pump. If you remove the top PS pump bolt and loosten the lower PS pump bolt about 1/2 way you can push the pump over with one hand while removing the water pump bolt.
no it cant i just finished my water pump install on my 2.4L and you have to un bolt the header pipe sorry!
You will need to drill the broken bolt out and install a heli-coil thread repair.
The torque of a water pump bolt can be requested from the manufacturer. The Chevy Trailblazer has a high torque for the water pump bolt.
Drain the radiator. Remove the pump belt, fan, and fan shroud. Unbolt the pump then remove it. Bolt the new pump on, and install the fan an shroud. Put the belt on and refill the radiator with fresh coolant.
how do you install a water pump on a2004 Isuzu axiom
which bolt
how do you install a water pump on a 1992 toyota camry
the water pump on the 4.3L vortec is easy. there are four bolt holding the water pump in place. these bolt hold your fan clutch also. the water pump and fan system.are built as one. remove these bolts and you are ready to change your water pump.
The steering pump is attached with 2 bolts. If you take the top bolt out and loosen the bottom bolt until it's almost completely out, you can move the pump/pulley enough to snake that bottom left water pump bolt out.
You first disconnect the battery, then drain the cooling system, discount belt from engine and water belt pulley, then remove the water pump bolts and remove the water pump, then you install the new water pump and put everything back.
Two bolts hold the tensioner on, remove them, install belt over camshaft pulley and around the water pump. replace tensioner, you'll probably have to have someone pull forward to allign the front bolt as it has tension on it now.