yes you can people put them in lincons for demolition derby cars mind you this is a very ruff way but if you go to a local demo and find a guy who runs Ford bodys and Chevy engines and been doing it for a few years he should be very helpfull
Sure, with some fabrication and $$$ anything is possible.
If the horn does not work in the 1998 Chevy Prism and the vehicle was purchased used in this condition, it is quite possible that the previous owner cut the horn wires to stop the annoying security alarm. It is also possible that the fuse for the horn is blown.
Yes they will fit... but tires will need to be as small as possible.
location of thermostat in 1998 Lincoln continental
How to unlock radio in 1998 Chevy silverado
HOW TO REPLACE A STARTER ON A 1998 CHEVY MALIBU
HOW TO GET A PULLEY OFF A 1998 CHEVY BLAZER
With enough money anything is possible even though Chevy 350 is a small block.With enough money anything is possible even though Chevy 350 is a small block.
Yes without a doubt.
A 1998 Chevy Camaro uses R134a.
What type of oil does a 1998 Lincoln Continental use
Where to find flasher on 1998 Lincoln Continential
Where is the fuel filter located on a 1998 Chevy Malibu?"
how do i remove an antenna to a 1998 chevy express 1500 van
To disconnect the coil springs on a 1998 Chevy Venture you first need to jack the vehicle up and release as much stress from the springs as possible. You may need to find a spring compressor to release the springs.
Do a Google search " pictures of 1998 Lincoln Town Car "
If the front end is rattling after shocks were replaced on a 1998 Chevy Z71, it could be possible that a bolt was left in the wheel well behind the hubcap. It is also possible that not all of the bolts were tightened down securely.
Lincoln Capitols was created in 1998.
how reinstall a distributor on a 1998 chevy astro, and faun time
A 1998 Chevy astro has shocks instead of sturts.
How do you install a turn signal switch on a 1998 Chevy Tahoe?
Where is the fuel pressure regulator located on a 1998 Chevy van
I need diagram for 1998 chevy blazer fuse panel
no, 1998 is a year of its own, you will need a 98 trans