Want this question answered?
Usualy the tensioner or idler pulley is spring loaded and can be pulled backwards allowing enough slack for the belt to slip on easily On a 1992-1996 Beretta/Corsica, the upper engine mount needs to be removed in order to remove/replace the serpentine belt. Replace the belt, and reinstall the engine mount.
check this site out
A 96 Chevy Beretta Z26 has a 3100 V6 engine. The oil drain is located on the bottom of the oil pan, on a slight angle pointing down and towards the rear.
To replace the exterior mirror on a 1996 Beretta, find a small plate on the inside of your door. Remove the screws and install the new mirror.
I'm looking where the therma stat is location in a 1996 Chevy bratta at
oil leaks
Computer controlled and not adjustable
on my 92, it on the oil pan facing toward the rear on my 92, it on the oil pan facing toward the rear
The voltage regulator is built into the alternator.
The 1996 4.3L engine doesn't have a carburetor, it is fuel injected.
There are two of them on a 1996 Beretta. One is mounted in the rear exhaust manifold. You should be able to see it by looking under the hood, straight down the back of the engine. The other is located just before the catalytic converter. Poke your head under the car and look for the big "bubble" in the exhaust pipe closer to the engine.
The 3.1 was a V6